Translations:WB-MSx Consumer IR Manual/20/en

Operating mode

Recording the signal to the RAM from the remote control

To write a signal (only one) from the remote control to the RAM without putting it in the ROM - write 1 in the flag register at 5001. Further actions occur in the same way as described above to record the signal in ROM. After the recording is stopped in the storage registers at 2000, the signal will be stored as a sequence of numbers. You can edit this sequence as described above. Note: the contents of these storage registers are not stored when the device is powered off!

Playing a signal from memory

To play the signal from memory, write 1 to the flag register at 5002. The signal recorded in the storage registers starting with 2000will be played. In the absence of the marker of the end of the command will return an error. While the signal is playing, the flag register at 5002 will be set to 1 and then set to 0. While the signal is being played, no other operations with the IR transceiver via Modbus will be available.