Digital Output Module (WBIO-DO-HS-8)

Материал из Wiren Board
Это утверждённая версия страницы. Она же — наиболее свежая версия.
Другие языки:
WBIO-DO-SSR-8

Buy online

Purpose

The module is designed to control low-voltage loads: relays, low-voltage motors, signal lamps, etc

Technical specifications

Contains 8 outputs such as "High Side Switch" - when you turn on channel Vin voltage is supplied to the output.


The module is based on BTS4880R chip.

The outputs are protected against overload, short circuit, overheating, spikes when controlling the inductive load.

Parameter Value
Number of outputs 8
Number of groups 1
Output type High Side Switch
Switching voltage 11 - 45 V DC
Maximum switching current, per channel 0.6 A
Leakage current disabled output (each output) <10 µa
The channel resistance in the open state 200 mOhm
Module type O (non-inverted addr.)
Maximum power consumption 0.025 W
Width, DIN units 2
Size 36.3x90.2x57.5 mm
Terminals and wire section
Recommended wire cross-section with TSVI, mm2 0,75 — 1
Length of the standard sleeve NSVE, mm 8 (10 for adjusting screwless terminal blocks)
Torque of screws, N∙m 0,2 (for screw terminals)


Dimensions

Connection to the controller

See Activating the modules in the web interface of the controller

Load connection

the module requires an external power supply to the terminals Vin and GND (11 to 45V).

The ground of the module must be connected to the ground of the controller!

High Side Outputs working scheme

Device images and drawings


По ссылкам ниже вы можете скачать изображения и чертежи устройства WBIO-DO-SSR-8.

Corel Draw 2018: WBIO-DO-SSR-8.cdr.zip

Corel Draw PDF: WBIO-DO-SSR-8.cdr.pdf

Autocad 2013 DXF: Мы еще не подготовили чертеж этого устройства. Вы можете запросить чертеж устройства "Digital output module WBIO-DO-SSR-8" на портале техподдержки Wiren Board (необходима регистрация).