История
1 августа 2024
27 ноября 2019
26 ноября 2019
19 июля 2019
Новая страница: «If this does not happen, you may have confused Rx and Tx. Or for any other reason.»
−57
Новая страница: «Now when you turn on the WirenBoard should immediately display the Linux console at boot. thumb|300px| Console at boot»
−87
Новая страница: «thumb|300px| Putty settings Connect the USB-UART adapter. Open the session.»
−44
Новая страница: «In the settings, specify the connection type - serial, speed - 115200, line - COM3 (usually COM3, otherwise see the device Manager list of ports).»
−101
Новая страница: «For Windows users: download [http://www.chiark.greenend.org.uk/~sgtatham/putty/download.html Putty ] and run it.»
−33
Новая страница: «=== Debug UART === See here .»
−38
Новая страница: «Connect the external power supply to the power jack. Or supply power to terminals 17 (Vin) and 18 (GND). Permissible voltage range - 5-22 V.»
−87
Новая страница: «=== Power Supply ===»
−2
Новая страница: «Insert into the connector (on the side of the OLinuXino-MICRO Board).»
−28
Новая страница: «Create a microSD card with the image.»
−14
Новая страница: «=== Flash card ===»
−12
Нет описания правки
Новая страница: «'''Do not place the GSM antenna near the processor.''' Aiming at the quartz of the processor causes it to reboot. Turn the antenna away from the USB and Ethernet…»
−117
Новая страница: «Antennas for GPS and GSM are connected from the outside of the board.»
−33
Новая страница: «For connecting the antenna you need to remove the red charge, and a light press until it clicks to put the corresponding connector (it is convenient to do that wi…»
−77
Новая страница: «Connector u.fl for WiFi is inside the Wiren Board.»
−32
Нет описания правки
Новая страница: «thumb|300px|wifi antenna Connection thumb|300px|Connecting GPS and GSM antennas File:Map Connector.JPG|thumb…»
−101
Новая страница: «Wiren Board controller: Getting started»
+2622