История
22 сентября 2022
Нет описания правки
−1
Нет описания правки
+66
Нет описания правки
−47
Нет описания правки
−34
Новая страница: «It is almost never possible to access the controller at the address received by the GPRS interface - cellular operators usually issue [B5%D0%BC-%D0%BE%D1%82%D0%BB%D0%B8%D1%87%D0%B8%D0%B5-%D0%B1%D0%B5%D0%BB%D0% BE%D0%B3%D0%BE-%D0%B8-%D1%81%D0%B5%D1%80%D0%BE%D0%B3%D0%BE-IP-%D0%B0%D0%B4 %D1%80%D0%B5%D1%81%D0%B0 are "gray" IP addresses] and cannot be accessed from the Internet.»
−193
Новая страница: «By default, no password is required to connect to the controller via Wi-Fi, but you can change this.»
−516
Новая страница: «When connected via Wi-Fi, the controller will be available at '''[http://192.168.42.1 192.168.42.1]'''.»
+172
Нет описания правки
+35
Обновление для соответствия новой версии исходной страницы.
+865
28 апреля 2021
28 мая 2019
Новая страница: «If you have connected the controller via Ethernet or Wi-Fi to your router, the IP address of the controller can be seen in the web interface of the router. Typica…»
−106
Новая страница: «==Method 3 (without connecting to the controller)==»
−23
Новая страница: «400px|thumb|IP addresses can be viewed by connecting to the console via [[Debug UART|Debug UART]] Connect to the controller through the […»
−203
Новая страница: «==Method 2==»
−6
Новая страница: «By default the controller creates a Wi-Fi network ''WirenBoard'' without a password. Connect to it,the address of the controller is always ''192.168.42.1''. In th…»
−141
Новая страница: «==Method 1==»
−6
Новая страница: «A controller can have multiple IP addresses because it can connect to networks in several ways: *via Ethernet - by default gets IP address from router via DHCP, *…»
−600
Нет описания правки
−2