История
29 мая 2019
Нет описания правки
+16
Нет описания правки
+8
Нет описания правки
−44
Новая страница: «No special configuration is required. You need to make sure that the corresponding slot (Internal slot 1 or Internal slot 2) is set to "None".»
−84
Новая страница: «==Configuration== Configuration of the web interface is carried out in the section Configs => Hardware Modules Configuration.»
−51
Нет описания правки
+5
Новая страница: «thumb|300px|Extension module RS485-ISO»
−17
Новая страница: «The module contains a 150 Ohm terminator between lines A and B. To enable it, you need to close the jumper on the top side of the board.»
−90
Нет описания правки
−15
Обновление для соответствия новой версии исходной страницы.
+797
20 апреля 2016
14 января 2016
Новая страница: «For work you need to disable hardware flow control. Additional configuration port as the RS485 is required.»
−108
Новая страница: «* /dev/ttyAPP2 - when installed in first slot for expansion module (MOD1) * /dev/ttyAPP3 - when installed in second slot for expansion module (MOD2)»
−61
Новая страница: «Port is available in the system as»
−16
Новая страница: «==== Operation ====»
−3
Новая страница: «{| class="wikitable" !Terminal !Function |- |O1 |A (D+) |- |O2 |B (D-) |- |O3 |Isolated GND (Common, C) |}»
−10
Новая страница: «RS485 signals goes to terminals extansion module O1-O3.»
−41
Новая страница: «== Pinout ==»
−14
Новая страница: «Module with galvanically isolated RS-485 interface. The speed of up to 1 Mbit / s.»
−51
Новая страница: «Wiren Board 5: RS485-ISO Extansion Module»
+901