12 063
правки
(Новая страница: «== Data exchange == At the physical level, the module is connected via RS-485 interface. Modbus RTU Protocol is used to control the meter. In Wirenb…») |
(Новая страница: «== Installation== The relay module is freely mounted in mounting boxes, cable channels, etc.») |
||
Строка 156: | Строка 156: | ||
At the physical level, the module is connected via [[RS-485/en|RS-485]] interface. Modbus RTU Protocol is used to control the meter. In Wirenboard Devices, Modbus data is transmitted over RS-485 communication lines. See the [[Протокол Modbus/en|Modbus Protocol]] page for details. Modbus-the address of the counter is set at the factory and marked on the label. The address can be changed programmatically. Details refer to the [[#Modbus Parameters| Modbus parameters]]. | At the physical level, the module is connected via [[RS-485/en|RS-485]] interface. Modbus RTU Protocol is used to control the meter. In Wirenboard Devices, Modbus data is transmitted over RS-485 communication lines. See the [[Протокол Modbus/en|Modbus Protocol]] page for details. Modbus-the address of the counter is set at the factory and marked on the label. The address can be changed programmatically. Details refer to the [[#Modbus Parameters| Modbus parameters]]. | ||
== | == Installation== | ||
The relay module is freely mounted in mounting boxes, cable channels, etc. | |||
Блоки безвинтовых зажимов на плате реле служат для подключения линий питания, управления (RS-485) и входных контактов. При использовании при монтаже наконечников типа НШВИ необходимо, чтобы диаметр изолированных манжет не превышал 3,6 мм, сечение провода — 0,75 мм<sup>2</sup>, а длина проводящей втулки — 5—6 мм. Винтовые зажимы принимают провод сечением 2,5—4 мм<sup>2</sup>. Сечение провода должно соответствовать коммутируемой нагрузке. | Блоки безвинтовых зажимов на плате реле служат для подключения линий питания, управления (RS-485) и входных контактов. При использовании при монтаже наконечников типа НШВИ необходимо, чтобы диаметр изолированных манжет не превышал 3,6 мм, сечение провода — 0,75 мм<sup>2</sup>, а длина проводящей втулки — 5—6 мм. Винтовые зажимы принимают провод сечением 2,5—4 мм<sup>2</sup>. Сечение провода должно соответствовать коммутируемой нагрузке. |
правки