12 063
правки
(Новая страница: «#Download the file ''wb5_usbfw.sb'' on your computer [https://github.com/contactless/wirenboard/tree/master/contrib/u-boot here]. #Assemble the program Сбо…») |
|||
Строка 29: | Строка 29: | ||
#:to find out how the drive is defined in the system. | #:to find out how the drive is defined in the system. | ||
#:'''Attention! If you make a mistake with the definition of the drive name, and in the next paragraph substitute the name corresponding to your other drive, its contents will be lost.''' | #:'''Attention! If you make a mistake with the definition of the drive name, and in the next paragraph substitute the name corresponding to your other drive, its contents will be lost.''' | ||
#To write firmware to the controller, replace in the command below | #To write firmware to the controller, replace the following in the command below | ||
/X/XX/XXXXX_emmc_wb5.img the path to the pre-extracted firmware file, | #*''/X/XX/XXXXX_emmc_wb5.img'' - replace with the path to the pre-extracted firmware file, | ||
/dev/sdX | #*''/dev/sdX'' - replace with the name of the partition under which the drive is defined in the system, | ||
and run the command | #:and run the command | ||
$ sudo dd if=/X/XX/XXXXX_emmc_wb5.img of=/dev/sdX bs=1M conv=fdatasync && sync | <syntaxhighlight lang="bash">$ sudo dd if=/X/XX/XXXXX_emmc_wb5.img of=/dev/sdX bs=1M conv=fdatasync && sync</syntaxhighlight> | ||
After recording is complete, disconnect the controller from the USB, | #After recording is complete, disconnect the controller from the USB, turn off the controller, and then turn it back on. |
правки