12 063
правки
(Новая страница: «{| class="wikitable" | thumb|center|300px|Installing module into Mod3 slot || Файл:RF_SMA_Mounting_Place.png|thumb|center|300px|…») |
(Новая страница: «== Work in Wiren Board 6== After adding the module, the ISM Radio device and Noolite device templates should appear in the web interface of the controller. If the…») |
||
(не показаны 4 промежуточные версии этого же участника) | |||
Строка 22: | Строка 22: | ||
|} | |} | ||
== | ==Configuration== | ||
Configuration is carried out in the web interface, section Configs => Hardware Modules Configuration. | |||
Choose "WBE2S-R-433MHZ" in Internal slot 3 and click Save. | |||
The device is detected immediately, no reboot is required. | |||
== | == Work in Wiren Board 6== | ||
After adding the module, the ISM Radio device and Noolite device templates should appear in the web interface of the controller. If there are radio transmitters in the reception area (supporting packet data transmission at 433 MHz), the control '''''rx raw''''' will increase its value with each received data packet. If there are Oregon Scientific sensors in the radio availability zone (for example, THGN132N), when receiving data from them, the value of the control '''''rx oregon''''' will increase, and the corresponding devices with controls displaying the values of the sensor parameters will be created in the web interface. | |||
{| class="wikitable" | {| class="wikitable" | ||
| [[ | | [[File:Install_WBE2S-R-433MHZ.png|thumb|450px|Installing the WBE2S-R-433MHZ module in the web interface] ||[File:ISM_Radio.png|thumb|300px|left| ISM Radio Device]]||[[File:Oregon_THGN132N.png|thumb|300px|left| Oregon Scientific THGN132N]] | ||
|} | |} |
правки