12 063
правки
Модуль выходов "сухой контакт" (оптореле) WBE-DO-SSR-2/en: различия между версиями
Модуль выходов "сухой контакт" (оптореле) WBE-DO-SSR-2/en (просмотреть исходный код)
Версия 19:27, 1 июля 2019
, 4 года назадНовая страница: «The relay control signals are on the RX (K1) and IRQ (K2) contact of the extension module»
(Новая страница: «Once added, two additional outputs appear in the Devices next to the controller outputs (the Discrete I/O section).») |
(Новая страница: «The relay control signals are on the RX (K1) and IRQ (K2) contact of the extension module») |
||
| (не показаны 4 промежуточные версии этого же участника) | |||
| Строка 69: | Строка 69: | ||
Once added, two additional outputs appear in the Devices next to the controller outputs (the Discrete I/O section). | Once added, two additional outputs appear in the Devices next to the controller outputs (the Discrete I/O section). | ||
When adding a device is detected immediately, a reboot is not required. | |||
[[Файл:OptoRelay.jpg|thumb| | [[Файл:OptoRelay.jpg|thumb| WBE-DO-OR-2 for Wiren Board 5 | ||
]] | ]] | ||
== MQTT == | ==MQTT == | ||
{| class="wikitable" | {| class="wikitable" | ||
! | !Slot | ||
! | !Terminal | ||
! | !Output | ||
! | !Channel (MQTT) | ||
! | !Topic (MQTT) | ||
|- | |- | ||
| rowspan="2" |MOD1 | | rowspan="2" |MOD1 | ||
| Строка 107: | Строка 107: | ||
== | ==Technical detail== | ||
The relay control signals are on the RX (K1) and IRQ (K2) contact of the extension module | |||