12 063
правки
(Новая страница: «To send a button press, you should publish the message in the format '''<button name>:<button name>''' in the topic "/devices/wb-lirc/controls/Key/on"») |
(Новая страница: «== Troubleshooting == = = = = Not working reception === * Make sure the driver "sees" pulses from the receiver. ** Stop service '''lirc''' (command "service lirc…») |
||
Строка 75: | Строка 75: | ||
To send a button press, you should publish the message in the format '''<button name>:<button name>''' in the topic "/devices/wb-lirc/controls/Key/on" | To send a button press, you should publish the message in the format '''<button name>:<button name>''' in the topic "/devices/wb-lirc/controls/Key/on" | ||
== | == Troubleshooting == | ||
=== | = = = = Not working reception === | ||
* | * Make sure the driver "sees" pulses from the receiver. | ||
** | ** Stop service '''lirc''' (command "service lirc stop") | ||
** <pre>root@wirenboard:~# mode2 -d /dev/lirc1</pre> | ** <pre>root@wirenboard:~# mode2 -d /dev/lirc1</pre> | ||
**: | **: The numbers should run when you press the buttons on the remote, if not - the problem is in the "hardware" or in the mismatch of the carrier of the remote and the receiver. You should try using a different receiver. | ||
* | * Make sure that '''lirc''' can decode pulse sequences according to the configuration of the remote control: | ||
** | ** Run back '''lirc''' ('service lirc start') | ||
** <pre>root@wirenboard:~# irw</pre> | ** <pre>root@wirenboard:~# irw</pre> | ||
**: | **: Due to run lines when you press the buttons on the remote. If '''mode2''' works and '''irw''' doesn't, there is a problem with the remote config. It is worth trying to use another config, or create a new one. | ||
=== Не работает передача === | === Не работает передача === |
правки