12 063
правки
I/O Mapping Matrix/en: различия между версиями
Новая страница: «== The programming examples of the interaction of inputs and outputs =»
(Новая страница: «Re-simulation of the input state after 20 minutes (mode 5) means that every 20 minutes an action will be performed on the output (according to the matrix), as if…») |
(Новая страница: «== The programming examples of the interaction of inputs and outputs =») |
||
| Строка 137: | Строка 137: | ||
Re-simulation of the input state after 20 minutes (mode 5) means that every 20 minutes an action will be performed on the output (according to the matrix), as if the input has just changed the state: if the input is closed, then the action is performed on the rising edge. If open — the on the back. This mode provides additional reliability when controlling the relay leakage sensors connected to the inputs. The following scenario is worked out: when the inlet is closed by the leakage sensor, the ball valve closes the water. At some point, the command to open the crane (for example, Modbus) comes. But, if the leak is still fixed by the sensor, after 20 minutes the tap will be closed again. | Re-simulation of the input state after 20 minutes (mode 5) means that every 20 minutes an action will be performed on the output (according to the matrix), as if the input has just changed the state: if the input is closed, then the action is performed on the rising edge. If open — the on the back. This mode provides additional reliability when controlling the relay leakage sensors connected to the inputs. The following scenario is worked out: when the inlet is closed by the leakage sensor, the ball valve closes the water. At some point, the command to open the crane (for example, Modbus) comes. But, if the leak is still fixed by the sensor, after 20 minutes the tap will be closed again. | ||
== | == The programming examples of the interaction of inputs and outputs = | ||
Рассмотрим несколько примеров программирования программирования взаимодействия входов и выходов на примере релейного модуля WB-MR6C с прошивкой 1.9.4. Модуль имеет 7 входов типа "сухой контакт" и 6 релейных выходов. Вход 0 по умолчанию используется для отключения всех реле модулей, а кнопки 1 — 6 для управления модулями реле. | Рассмотрим несколько примеров программирования программирования взаимодействия входов и выходов на примере релейного модуля WB-MR6C с прошивкой 1.9.4. Модуль имеет 7 входов типа "сухой контакт" и 6 релейных выходов. Вход 0 по умолчанию используется для отключения всех реле модулей, а кнопки 1 — 6 для управления модулями реле. | ||