12 063
правки
Inspektor SCADA/en: различия между версиями
Новая страница: «to view *real-time* error messages»
(Новая страница: «5. After successfully adding, go to the access keys section again. Copy the created access key.») |
(Новая страница: «to view *real-time* error messages») |
||
| (не показано 10 промежуточных версий этого же участника) | |||
| Строка 46: | Строка 46: | ||
[[Файл:Inspektor-howto-3.png|500px]] | [[Файл:Inspektor-howto-3.png|500px]] | ||
=== | === Setting up a connection on the controller === | ||
1. | 1. Open the controller web interface in a browser. Select the "SCADA Client" submenu in the Configs menu. | ||
[[Файл:Inspektor-howto-4.png|500px]] | [[Файл:Inspektor-howto-4.png|500px]] | ||
2. | 2. Add the correct values to the client ID and key fields. Save with Save button | ||
[[Файл:Inspektor-howto-5.png|500px]] | [[Файл:Inspektor-howto-5.png|500px]] | ||
3. | 3. Make sure the controller appears in the Inspektor SCADA interface: | ||
[[Файл:Inspektor-howto-6.png|500px]] | [[Файл:Inspektor-howto-6.png|500px]] | ||
4. | 4. Make sure that channel management is working. You can enable buzzer: | ||
[[ Файл:Inspektor-howto-7.png|500px]] | [[ Файл:Inspektor-howto-7.png|500px]] | ||
=== | === Configure channels for synchronization === | ||
The necessary channels must be explicitly added to the list in the configuration interface: | |||
[[File:Inspektor-howto-5.png|500px]] | [[File:Inspektor-howto-5.png|500px]] | ||
Channel names can be found in the Settings section. More information about channels, see [[MQTT/en]] | |||
=== | === Debug=== | ||
If something does not work, you can run the command on the controller | |||
<pre> | <pre> | ||
| Строка 80: | Строка 80: | ||
</pre> | </pre> | ||
to view *real-time* error messages | |||