12 063
правки
WB-M1W2 1-Wire to Modbus Temperature Measurement Module/en: различия между версиями
WB-M1W2 1-Wire to Modbus Temperature Measurement Module/en (просмотреть исходный код)
Версия 14:16, 19 июля 2019
, 4 года назадНовая страница: «To display the registers corresponding to the discrete inputs, select the template "WB-M1W2 DI":»
(Новая страница: «Since firmware version 4.0.0, the WB-M1W2 Converter allows you to configure each of the two inputs as a discrete input. The input mode is set in registers 275-276…») |
(Новая страница: «To display the registers corresponding to the discrete inputs, select the template "WB-M1W2 DI":») |
||
| Строка 380: | Строка 380: | ||
Since firmware version 4.0.0, the WB-M1W2 Converter allows you to configure each of the two inputs as a discrete input. The input mode is set in registers 275-276 (see the table above). In Wiren Board controllers this mode is configured through the Setup-section of the driver. | Since firmware version 4.0.0, the WB-M1W2 Converter allows you to configure each of the two inputs as a discrete input. The input mode is set in registers 275-276 (see the table above). In Wiren Board controllers this mode is configured through the Setup-section of the driver. | ||
To display the registers corresponding to the discrete inputs, select the template "WB-M1W2 DI": | |||
[[File:M1w2 as discrete inputs example.png|400px|thumb|center|Пример настройки WB-M1W2 на дискретные входы.]] | [[File:M1w2 as discrete inputs example.png|400px|thumb|center|Пример настройки WB-M1W2 на дискретные входы.]] | ||