translator, wb_editors
4323
правки
WBMZ2-BATTERY Backup Power Module/en: различия между версиями
WBMZ2-BATTERY Backup Power Module/en (просмотреть исходный код)
Версия 21:05, 29 августа 2022
, 1 год назадНет описания правки
Matveevrj (обсуждение | вклад) |
Matveevrj (обсуждение | вклад) |
||
| Строка 22: | Строка 22: | ||
There is a green LED charge indicator on the module next to the on/off button. The indicator lights up when external power is applied to the module and the battery is charging. The indicator does not light if the controller is not supplied or the battery is fully charged. | There is a green LED charge indicator on the module next to the on/off button. The indicator lights up when external power is applied to the module and the battery is charging. The indicator does not light if the controller is not supplied or the battery is fully charged. | ||
=== | === Panel installation === | ||
The battery is charged only when its temperature is between 0°C and 45°C. | |||
Do not overheat the controller. Do not install near or above contactors, relays, or other heating equipment. | |||
==Technical specifications== | ==Technical specifications== | ||
<!--[[File:Mezonin.png|500px|thumb|right|Inserting module in the mezonin slot]]--> | <!--[[File:Mezonin.png|500px|thumb|right|Inserting module in the mezonin slot]]--> | ||
The module contains a charge circuit Li-Ion battery with charge protection at low and high temperatures. Battery capacity is 2200 mAh. Connection to the controller is carried out by two loops: power and control loop, and two-wire loop of on/off control. Charging current is 300 mA, the time required to fully charge the battery is ~7 hours. | The module contains a charge circuit Li-Ion battery with charge protection at low and high temperatures. Battery capacity is 2200 mAh. Connection to the controller is carried out by two loops: power and control loop, and two-wire loop of on/off control. Charging current is 300 mA, the time required to fully charge the battery is ~7 hours. | ||
=== LIR18650-PCM battery parameters === | === LIR18650-PCM battery parameters === | ||
| Строка 68: | Строка 65: | ||
|} | |} | ||
== Removing and installing the module == | == Removing and installing the module == | ||
If the battery module was purchased separately, you must connect the positive contact of the battery to the connector before installation, as shown in the figure. | If the battery module was purchased separately, you must connect the positive contact of the battery to the connector before installation, as shown in the figure. | ||