16 343
правки
Gas sensor WB-MSGR/en: различия между версиями
Нет описания правки
FuzzyBot (обсуждение | вклад) (Обновление для соответствия новой версии исходной страницы.) Метка: отменено |
Метка: отменено |
||
| Строка 34: | Строка 34: | ||
|} | |} | ||
== Specifications == | == Specifications == | ||
{| class="wikitable" | {| class="wikitable" | ||
| Строка 112: | Строка 111: | ||
| up to 98%, without condensation | | up to 98%, without condensation | ||
|} | |} | ||
== Installation== | == Installation== | ||
[[File:WB-MS-dim.png|200px|thumb|right|WB-MSGR MODULE Mounting dimensions]] | [[File:WB-MS-dim.png|200px|thumb|right|WB-MSGR MODULE Mounting dimensions]] | ||
[[File:Installation_WB5_+wb-msgr+syren.png|450px|thumb|left|Connect the WB-MSGR MODULE to the WB5 controller. If the configured concentration of the dangerous gas is exceeded, a siren is triggered.]] | [[File:Installation_WB5_+wb-msgr+syren.png|450px|thumb|left|Connect the WB-MSGR MODULE to the WB5 controller. If the configured concentration of the dangerous gas is exceeded, a siren is triggered.]] | ||
The sensor can be mounted on a standard 35 mm wide DIN rail and occupies a width of about 2.5 DIN modules. The sensor also has holes for direct attachment to any flat surface. The diameter of the holes — 4mm, the distance between the centers — 41 mm. the Distance between the head of the fixing screw and the surface (depth) — 11 mm. | The sensor can be mounted on a standard 35 mm wide DIN rail and occupies a width of about 2.5 DIN modules. The sensor also has holes for direct attachment to any flat surface. The diameter of the holes — 4mm, the distance between the centers — 41 mm. the Distance between the head of the fixing screw and the surface (depth) — 11 mm. | ||
The module screw terminal block ([[#wbmsgrphoto|see figure "WB-MSGR SENSOR"]]) is used to connect power lines (V+ and GND) and control lines via RS-485 (RS-485 A and B). In the version with built-in relay, the upper screw terminals are connected to NC, COM, NO relay contacts. | The module screw terminal block ([[#wbmsgrphoto|see figure "WB-MSGR SENSOR"]]) is used to connect power lines (V+ and GND) and control lines via RS-485 (RS-485 A and B). In the version with built-in relay, the upper screw terminals are connected to NC, COM, NO relay contacts. | ||