translator, wb_editors
4539
правок
(Новая страница: «== First time start == The first switch-on of the device may take a long time (3-4 minutes). The first time you turn it on, SSH secret keys are generated and the…») |
Matveevrj (обсуждение | вклад) Метки: правка с мобильного устройства правка из мобильной версии |
||
(не показано 13 промежуточных версий 2 участников) | |||
Строка 5: | Строка 5: | ||
== Preparing to power on == | == Preparing to power on == | ||
Before | Before you start | ||
#Be sure to | #Be sure to install a microSD card with the software image (included) into the device. | ||
#Install a | #Install a Micro-sized SIM card (if you plan to use the GSM module). | ||
#Check the switch | #Check the position of the switch.! N!#Connect the power supply. | ||
#Connect the power supply. | ==microSD card== | ||
Installed in the memory card slot ('''top''') with the contacts '''up'''. | |||
Installed in the | ===Micro-SIM card=== | ||
=== Micro-SIM card === | Installed in the Micro-SIM card slot ('''bottom''') with the contacts '''down''' with the cut corner inward. | ||
===Switch position=== | |||
=== Switch position === | The pressed side with a dot is '''off'''. | ||
The pressed side with a dot is 'off'. | Power supply | ||
There are three types: standard, DIN rail, PoE injector. | |||
There are three types: standard, DIN | '''Do not connect two different power supplies at the same time''', this will burn them and the controller. | ||
'''Do not connect two different power supplies at the same time''', | The standard power supply is connected to the corresponding connector. | ||
The standard power supply is connected to the | The DIN rail power supply is connected with wires to the large terminal blocks Vin and Gnd (next to with a relay, see the [http://wirenboard.com/wiki/index.php/%D0%A4%D0%B0%D0%B9%D0%BB:WB3.5.png diagram]) | ||
The power supply | Passive PoE power supply is connected Ethernet cable. | ||
=== Antenna connection === | === Antenna connection === | ||
Строка 35: | Строка 34: | ||
The first switch-on of the device may take a long time (3-4 minutes). The first time you turn it on, SSH secret keys are generated and the serial number of the device is initialized. | The first switch-on of the device may take a long time (3-4 minutes). The first time you turn it on, SSH secret keys are generated and the serial number of the device is initialized. | ||
== IP- | == IP-address == | ||
When connected via Ethernet, the Wiren Board Smart Home controller automatically receives an IP address via DHCP. You can find the IP address that the device received in the list of connected clients in the administrative interface of your router. | |||
== | == SSH access and console == | ||
Standard username and password: | |||
user: '''root''', password '''wirenboard''' | |||
== | == Software Update == | ||
We recommend you to upgrade your software. See | |||
== | ==See also== | ||
[[Программное обеспечение Wiren Board]] | [[Программное обеспечение Wiren Board/en| Wiren Board Software]] |