WB-MIR v2 - Modbus IR Remote Control/en: различия между версиями
(Новая страница: «| 104-105 || input || R|| || 32-bit unsigned int || uptime counter in seconds |-») |
(Новая страница: «|- |110 |holding |RW |96 |baud rate / 100 |RS-485 port speed, "'divided by 100"'. Permissible speeds: 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200 <br>(U…») |
||
Строка 165: | Строка 165: | ||
|96 | |96 | ||
|baud rate / 100 | |baud rate / 100 | ||
| | |RS-485 port speed, "'divided by 100"'. Permissible speeds: 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200 <br>([[UART_Communication_Settings/en|configure RS-485 communication parameters for Wiren Board Modbus devices]]) | ||
| rowspan="3" |>3.1.0 | | rowspan="3" |>3.1.0 | ||
|- | |- | ||
Строка 173: | Строка 173: | ||
|0 | |0 | ||
| | | | ||
| | |configure the RS-485 port parity bit. Valid values: 0 - no parity bit (none), 1 - odd (odd), 2 - even (even) | ||
|- | |- | ||
|112 | |112 | ||
Строка 180: | Строка 180: | ||
|2 | |2 | ||
| | | | ||
| | |number of stop bits of RS-485 port. Valid values: 1, 2 | ||
|- | |- | ||
| | | | ||
Строка 194: | Строка 194: | ||
|RW | |RW | ||
|0 | |0 | ||
| | |other than 0 | ||
| | |write to the register causes a reset of the module without saving state | ||
| | | | ||
|- | |- | ||
Строка 203: | Строка 203: | ||
| - | | - | ||
|mV | |mV | ||
| | |current supply voltage of the module | ||
| | | | ||
|- | |- | ||
Строка 211: | Строка 211: | ||
|1 | |1 | ||
| | | | ||
|Modbus | |The Modbus address of the device | ||
| | | | ||
|- | |- | ||
| 129 (0x81) || holding || RW || 0 || 0 | | 129 (0x81) || holding || RW|| 0 || 0 or 1 || Switch to bootloader mode || starting with firmware 4.5.0 | ||
|- | |- | ||
|200-206 | |200-206 | ||
|input | |input | ||
|R | |R | ||
| | |see [[Sensors Modbus Management/en|device Signature]] | ||
| | | | ||
| | |signature | ||
| | | | ||
|- | |- | ||
Строка 228: | Строка 228: | ||
|R | |R | ||
| | | | ||
|__date__ | |__date__ _ _ time__ | ||
| | |the build date of the firmware | ||
| | | | ||
|- | |- | ||
Строка 237: | Строка 237: | ||
|216 | |216 | ||
|°C × 100 (signed) | |°C × 100 (signed) | ||
| | |Self-heating compensation of the built-in temperature sensor. | ||
The register value is subtracted from the temperature measured by the built-in sensor (register 6) | |||
| | | | ||
|- | |- | ||
Строка 245: | Строка 245: | ||
|R | |R | ||
| | | | ||
| | |string, null-terminated | ||
| | |firmware version | ||
| | | | ||
|- | |- | ||
Строка 254: | Строка 254: | ||
| | | | ||
|32-bit unsigned int | |32-bit unsigned int | ||
| | |unique identifier (S/N) | ||
| | | | ||
|- | |- | ||
Строка 269: | Строка 269: | ||
|RW | |RW | ||
|0 | |0 | ||
|0 | |0 or 1 | ||
| | |1-W input mode: 0 - 1-wire, 1 - discrete input | ||
| rowspan="3" |>=4.0.0 | | rowspan="3" |>=4.0.0 | ||
|- | |- | ||
Строка 278: | Строка 278: | ||
| | | | ||
|16-bit unsigned int | |16-bit unsigned int | ||
| | |Counter for 1-W input | ||
|- | |- | ||
|0 | |0 | ||
Строка 284: | Строка 284: | ||
|R | |R | ||
| | | | ||
|0 | |0 or 1 | ||
| | |Current state of input 1-W: 0 - open, 1 - GND closed. If 1-wire mode is selected for input, the value is always 0. | ||
|- | |- | ||
|16 | |16 | ||
Строка 291: | Строка 291: | ||
|R | |R | ||
| | | | ||
|0 | |0 or 1 | ||
| | |Sensor polling status 1-Wire input no. 1: 0 - sensor not connected, 1 - sensor connected and correctly polled | ||
| | |starting with firmware v.4.6.0 | ||
|} | |} | ||