12 063
правки
MOD-MRF24J40/en: различия между версиями
Новая страница: «The easiest way to do this is to short-circuit (e.g. solder) the legs 4 and 6 on the UEXT plug of the module.»
(Новая страница: «For Linux, you must use the INT interrupt output. In the module's UEXT connector, this signal is routed to the UART RX (4) pin, which makes it impossible to use i…») |
(Новая страница: «The easiest way to do this is to short-circuit (e.g. solder) the legs 4 and 6 on the UEXT plug of the module.») |
||
| Строка 24: | Строка 24: | ||
You need to connect the INT pin on the findings UEXT2, which is essentially a GPIO, for example on pin 6 UEXT2 (GPIO53). | You need to connect the INT pin on the findings UEXT2, which is essentially a GPIO, for example on pin 6 UEXT2 (GPIO53). | ||
The easiest way to do this is to short-circuit (e.g. solder) the legs 4 and 6 on the UEXT plug of the module. | |||
==Настройка== | ==Настройка== | ||