Вклад
25 июля 2019
Wiren Board NETMON-1/en
Новая страница: «Debug console (debug UART) is output to connector I2 (see below), as well as to the comb inside the case. The port has 3.3 V levels and requires a special USB-UAR…»
−143
Translations:Wiren Board NETMON-1/52/en
Новая страница: «Debug console (debug UART) is output to connector I2 (see below), as well as to the comb inside the case. The port has 3.3 V levels and requires a special USB-UAR…»
Wiren Board NETMON-1/en
Новая страница: «== Debug console ==»
−22
Translations:Wiren Board NETMON-1/51/en
Новая страница: «== Debug console ==»
Wiren Board NETMON-1/en
Новая страница: «See also RS-485 for information on working with RS-485 and connecting peripherals.»
−73
Translations:Wiren Board NETMON-1/50/en
Новая страница: «See also RS-485 for information on working with RS-485 and connecting peripherals.»
Wiren Board NETMON-1/en
Новая страница: «Linux devices: * /dev/ttyNSC0 - RS-485 on I8 connector * /dev/ttyNSC1 - RS-485 on I6 connector * /dev/ttyNSC2 - RS-232 on I4 connector * /dev/ttyNSC3 - RS-232 o…»
−67
Translations:Wiren Board NETMON-1/49/en
Новая страница: «Linux devices: * /dev/ttyNSC0 - RS-485 on I8 connector * /dev/ttyNSC1 - RS-485 on I6 connector * /dev/ttyNSC2 - RS-232 on I4 connector * /dev/ttyNSC3 - RS-232 o…»
Wiren Board NETMON-1/en
Новая страница: «Both RS-485 ports and one RS-232 port are output to RJ45 connectors on the front panel, one RS-232 port is output to RJ45 connector on the back panel.»
−75
Translations:Wiren Board NETMON-1/48/en
Новая страница: «Both RS-485 ports and one RS-232 port are output to RJ45 connectors on the front panel, one RS-232 port is output to RJ45 connector on the back panel.»
Wiren Board NETMON-1/en
Новая страница: «The Wiren Board NETMON-1 is equipped with two half-duplex RS-485 ports and two RS-232 ports (RX/TX only).»
−52
Translations:Wiren Board NETMON-1/47/en
Новая страница: «The Wiren Board NETMON-1 is equipped with two half-duplex RS-485 ports and two RS-232 ports (RX/TX only).»
Wiren Board NETMON-1/en
Новая страница: «== Serial ports ==»
−31
Translations:Wiren Board NETMON-1/46/en
Новая страница: «== Serial ports ==»
Wiren Board NETMON-1/en
Новая страница: «* discover * insert button into connector (picture) * insert sim card (picture) * insert sd card (picture) * turn on, check that the green top light is on *…»
−200
Translations:Wiren Board NETMON-1/45/en
Новая страница: «* discover * insert button into connector (picture) * insert sim card (picture) * insert sd card (picture) * turn on, check that the green top light is on *…»
Wiren Board NETMON-1/en
Новая страница: «== Preparation for work ==»
−16
Translations:Wiren Board NETMON-1/44/en
Новая страница: «== Preparation for work ==»
Translations:Wiren Board NETMON-1/43/en
Новая страница: «<!--»
Wiren Board NETMON-1/en
Новая страница: «It is recommended to use outputs for switching resistive load up to 5A @ 240V AC.»
−101
Translations:Wiren Board NETMON-1/42/en
Новая страница: «It is recommended to use outputs for switching resistive load up to 5A @ 240V AC.»
Wiren Board NETMON-1/en
Новая страница: «Rated relay current: 10A@240VAC (resistive load).»
−45
Translations:Wiren Board NETMON-1/41/en
Новая страница: «Rated relay current: 10A@240VAC (resistive load).»
Wiren Board NETMON-1/en
Новая страница: «Each relay is switchable, i.e. contacts NO (normally open), NC (normally closed), COM (common) are derived.»
−110
Translations:Wiren Board NETMON-1/40/en
Новая страница: «Each relay is switchable, i.e. contacts NO (normally open), NC (normally closed), COM (common) are derived.»
Wiren Board NETMON-1/en
Новая страница: «There are four groups of relay outputs, output on the connector terminals, on the front panel of the Wiren Board NETMON-1.»
−76
Translations:Wiren Board NETMON-1/39/en
Новая страница: «There are four groups of relay outputs, output on the connector terminals, on the front panel of the Wiren Board NETMON-1.»
Wiren Board NETMON-1/en
Новая страница: « thumb | 300px | Front panel relay outputs»
−43
Translations:Wiren Board NETMON-1/38/en
Новая страница: « thumb | 300px | Front panel relay outputs»
Wiren Board NETMON-1/en
Новая страница: «=== Front panel ===»
−18
Translations:Wiren Board NETMON-1/37/en
Новая страница: «=== Front panel ===»
24 июля 2019
Wiren Board NETMON-1/en
Новая страница: «On request, a configuration is available to use a common input to both outputs.»
−66
Translations:Wiren Board NETMON-1/36/en
Новая страница: «On request, a configuration is available to use a common input to both outputs.»
Wiren Board NETMON-1/en
Новая страница: «Rated relay current: 16A/250VAC. The relay opens only one (phase) wire. It is recommended to use outputs for switching resistive load up to 10A.»
−129
Translations:Wiren Board NETMON-1/35/en
Новая страница: «Rated relay current: 16A/250VAC. The relay opens only one (phase) wire. It is recommended to use outputs for switching resistive load up to 10A.»
Wiren Board NETMON-1/en
Новая страница: «Each group consists of an IEC-320-C14 plug (input) and an IEC-320-C13 socket (output). The input and output are connected via a relay. The relay is normally close…»
−125
Translations:Wiren Board NETMON-1/34/en
Новая страница: «Each group consists of an IEC-320-C14 plug (input) and an IEC-320-C13 socket (output). The input and output are connected via a relay. The relay is normally close…»
Wiren Board NETMON-1/en
Новая страница: «The Wiren Board NETMON-1 is equipped with two power switching groups on the rear panel.»
−50
Translations:Wiren Board NETMON-1/33/en
Новая страница: «The Wiren Board NETMON-1 is equipped with two power switching groups on the rear panel.»
Wiren Board NETMON-1/en
Новая страница: « thumb | 500px | Inputs/outputs for 220V control and GSM antenna connector»
−70
Translations:Wiren Board NETMON-1/32/en
Новая страница: « thumb | 500px | Inputs/outputs for 220V control and GSM antenna connector»
Wiren Board NETMON-1/en
Новая страница: «=== Back panel ===»
−15
Translations:Wiren Board NETMON-1/31/en
Новая страница: «=== Back panel ===»
Wiren Board NETMON-1/en
Новая страница: «== External load switching ==»
−29
Translations:Wiren Board NETMON-1/30/en
Новая страница: «== External load switching ==»
Wiren Board NETMON-1/en
Новая страница: «Wiren Board NETMON-1 has one USB port (Host, type A) inside the case. The port is designed to connect Wi-Fi sticks, 3G modems, etc.»
−78
Translations:Wiren Board NETMON-1/29/en
Новая страница: «Wiren Board NETMON-1 has one USB port (Host, type A) inside the case. The port is designed to connect Wi-Fi sticks, 3G modems, etc.»
Wiren Board NETMON-1/en
Новая страница: «== USB port==»
−5
Translations:Wiren Board NETMON-1/28/en
Новая страница: «== USB port==»
Wiren Board NETMON-1/en
Новая страница: «The GSM antenna is connected to the SMA connector on the back of the controller. If the GSM signal is weak, it is recommended to use a remote antenna and place i…»
−126