12 063
правки
(Новая страница: «In UART-CAN mode, the module can be installed in any expansion slot, so you can install two WBE-I-CAN-ISO modules») |
|||
(не показано 7 промежуточных версий этого же участника) | |||
Строка 10: | Строка 10: | ||
CAN interface signals are galvanically isolated from the controller. | CAN interface signals are galvanically isolated from the controller. | ||
Can be installed only to MOD2 extension slot. | |||
Can be installed only to | |||
Строка 44: | Строка 42: | ||
== | == Configuration == | ||
[[Файл:Hwconf-can.jpg|thumb|300px| | [[Файл:Hwconf-can.jpg|thumb|300px|CAN extension module]] | ||
Configuration is set in the web interface: Configs section => Hardware Modules Configuration. | |||
For CAN mode: in Internal slot 2, select "WBE-I-CAN-ISO" and click Save. | |||
For UART-CAN mode: make sure that the corresponding slot (Internal slot 1 or Internal slot 2) is set to "None". | |||
The device is detected immediately, no reboot is required. | |||
== Operation == | == Operation == | ||
In CAN mode, it is defined as can1. About can on Linux, see [[CAN/en| CAN]]. | |||
Module operates in UART-CAN mode identically to the RS-485 extension module, see [[Wiren Board 5: Модуль расширения RS485-ISO/en|description]]. | |||
== | == Compatibility table == | ||
{| class="wikitable" | {| class="wikitable" | ||
! | !Mode | ||
! | !Controller | ||
! | !Audit | ||
!MOD1 | !MOD1 | ||
!MOD2 | !MOD2 |
правки