12 063
правки
(Новая страница: «== Installation of modules == The relay module is mounted on a standard 35 mm wide DIN rail and occupies the width of 3 DIN modules.») |
(Новая страница: «Terminal blocks with 3.5 mm increments on the relay board are used to connect power and control lines (RS-485). The cross-section of wires connected to the screw…») |
||
Строка 216: | Строка 216: | ||
The relay module is mounted on a standard 35 mm wide DIN rail and occupies the width of 3 DIN modules. | The relay module is mounted on a standard 35 mm wide DIN rail and occupies the width of 3 DIN modules. | ||
Terminal blocks with 3.5 mm increments on the relay board are used to connect power and control lines (RS-485). The cross-section of wires connected to the screw terminals of the relay outputs must correspond to the power of the switched load: it is important not to exceed the recommended current — 16 A. | |||
Если устройство — последнее на линии RS-485, то между его входами A и B необходимо установить резистор-терминатор сопротивлением 120 Ом. Практика показывает, что в случае стендовых испытаний при небольшой длине линии RS-485 и небольшом количестве устройств терминатор на последнем устройстве в линии можно не устанавливать. | Если устройство — последнее на линии RS-485, то между его входами A и B необходимо установить резистор-терминатор сопротивлением 120 Ом. Практика показывает, что в случае стендовых испытаний при небольшой длине линии RS-485 и небольшом количестве устройств терминатор на последнем устройстве в линии можно не устанавливать. |
правки