История
6 сентября 2022
24 мая 2019
Нет описания правки
+3
Нет описания правки
−4
Нет описания правки
+3
Нет описания правки
Новая страница: «* Wiren Board 5 (terminals R1-R2): <b>R2 = 3150 Ohm, R1 = 1000kOhm</b>. * Wiren Board 4 (terminals R1-R2): <b>R2 = 3570 Ohm, R1 = 120kOhm</b>. * Wiren Board…»
−26
Новая страница: «For different versions:»
−10
Новая страница: «where N is the raw LRADC readings, I is the output current.»
−17
Новая страница: «<b> V </b> is input voltage LRADC measured by the processor:»
−41
Новая страница: «<b>R1</b> is parallel resistance (divider arm/leakage currents).»
−52
Новая страница: «<b>r</b> is the measured resistance, <b>R2</b> is the series resistance of the channel»
−60
Новая страница: «The resistance is calculated by the formula:»
−26
Новая страница: «=== Calculating the results ===»
−18
Нет описания правки
+10
Новая страница: «In the example 40 µa is the optimum current:»
−15
Новая страница: «It is necessary to set the maximum possible value of the output current at which the voltage on the LRADC does not exceed 1.85 V, i.e. the raw result is not equal…»
−113
Новая страница: «Disconnecting the current source: <pre> root@wirenboard:~# lradc-set-current off </pre>»
−16
Новая страница: «Setting 100 µa current:»
−18
Новая страница: «The maximum current is 300 µa. The current is set in increments of 20 µa.»
−36
Новая страница: «Command <b>lradc-set-current</b> (https://github.com/contactless/wirenboard/tree/master/utils/adc/resistance).»
−7
Новая страница: «Setting the output current is not supported by the driver, so it is implemented using the userspace application with direct memory access.»
−99
Новая страница: «=== Setting output current ===»
−23
Новая страница: «Use wb-adc-set-mux to select a channel(ADC)»
−20
Новая страница: «=== Channel selection ===»
−8
Новая страница: «(only for Wiren Board rev. 2.8) * For terminals 2-7: close the transistor. See Список GPIO, Управление низковол…»
−113
Новая страница: «=== Disable output ===»
−19
Новая страница: «Make sure the wb-homa-adc daemon is unloaded»
−22
Новая страница: «== The measuring procedure in the manual mode ==»
−20
Новая страница: «Resistance measurement is implemented in the wb-homa-adc driver, see ADC.»
−35
Новая страница: «See also the description in the documentation on the processor, p. 1334»
−30
Новая страница: «The LRADC channel of the processor that the Wiren Board uses to operate the ADC has an integrated current source. This allows to measure the resistance of the loa…»
−173
Новая страница: «ADC: resistance measurement - technical details»
+4082