История
18 июля 2019
3 июля 2019
Новая страница: «=== Transmission is not working === * Try to transmit referring to LIRC directly: <pre> root@wirenboard:~# irsend SEND_START Sony_RM-687C KEY_3 ... root@wirenboar…»
−227
Новая страница: «== Troubleshooting == = = = = Not working reception === * Make sure the driver "sees" pulses from the receiver. ** Stop service '''lirc''' (command "service lirc…»
−450
Новая страница: «To send a button press, you should publish the message in the format '''<button name>:<button name>''' in the topic "/devices/wb-lirc/controls/Key/on"»
−101
Новая страница: «Example: <pre> root@wirenboard:~# mosquitto_sub -v -t '/devices/wb-lirc/#' /devices/wb-lirc/meta/name IR Remote Control /devices/wb-lirc/controls/Key/meta/order 1…»
−5
Новая страница: «'''wb-mqtt-lirc''' creates a device "/devices/wb-lirc/", accepted clicks are published in the topic "/devices/wb-lirc/controls/Key" in the format '''<switch_name>…»
−152
Новая страница: «=== MQTT interface ===»
−9
Новая страница: «After completing configuration, restart the service '''lirc''' and '''wb-mqtt-lirc''' <pre> root@wirenboard:~# service lirc restart && service wb-mqtt-lirc restar…»
−60
Новая страница: «====Creating a new remote config ====»
−96
Новая страница: «====Download ready remote config ==== <pre> root@wirenboard:~# irdb-get update root@wirenboard:~# irdb-get find 687C sony/RM-687C.lircd.conf root@wirenboard:~# i…»
−47
Новая страница: «=== Installation and configuration === Required packages (wb-mqtt-lirc, lirc-scripts, wb-mqtt-lirc), as well as the correct config file /etc/lirc/hardware.conf is…»
−152
Новая страница: «Finally, the stream of events from '''lircd''' in message MQTT and back runs the demon '''wb-mqtt-lirc'''»
−54
Новая страница: «This device interacts with daemon '''lircd''' from package [http://www.lirc.org/ LIRC] that provides decoding of the pulse sequence in the event pressed on the re…»
−287
Нет описания правки
+20
Новая страница: «At the kernel level for the work with IR to Wiren Board 5 the driver meets the "'lirc-pwm"'. It provides the / dev/lirc1 device.»
−56
Новая страница: «== Hardware ==»
−25
Новая страница: «=== Technical details === Mini-jack 3.5 mm Pinout on Wiren Board 5 : * Tip (left audio channel) - 5V power/IR transmission. * Ring (right audio channel) - IR…»
−425
Новая страница: «To transmit IR signals it is recommended to use a ready combined IR transceiver WB-CIR-TR, Samsung IR Blaster bn96/26652a or similar.»
−109
Новая страница: «To receive IR signals, you need to connect the receiver (combined WB-CIR-TR transceiver). The nominal carrier frequency of the receiver must be approximately the…»
−218
Новая страница: «On Wiren Board 5 (before revision 5.6.1) the required signals are output to the 3.5 mm…»
−209
Новая страница: «300px|thumb|right|IR receiver 300px|thumb|right|IR transmitter '''Warning! In revisions 5.8…»
−120
Новая страница: «== Hardware ==»
−23
Новая страница: «This article describes how to receive and transmit signals from home appliances that operate in the infrared (that is, most of the remotes from TVs, air condition…»
−183
Новая страница: «Consumer IR»
+8710