WBIO-DI-DR-8 I/O Module
Шаблон:DisplayTitle: Discrete inputs dry contact module (WBIO-DI-DR-8)
Applicability
Connection of pulse counters, buttons, switches, sensors with dry contact output.
Technical specifications
Contains 8 dry contacts inputs with group galvanic isolation. The scheme of inputs is shown in the figure. The terminal is supplied by ~ 4.5 V voltage, when the ground fault,flows a small (1mA) current, causing the operation of the input.
Parameter | Value |
---|---|
Number of inputs | 8 |
Isolated input groups | 1 |
Input type | dry contact,
the opening by the current at ground fault |
Operation condition | GND input lockout |
Tripping current | 1 mA |
Minimum pulse width to trigger | 10 MS |
Minimum time between consecutive signals | 5 MS |
Voltage of "wetting" | 4.5 V |
Module type | "I" (inverted address scheme) |
Maximum power consumption | 0.1 W |
Width, DIN units | 2 |
Size | 36,3x90,2x57,5 mm |
"'Terminals and wire section'" | |
---|---|
Recommended wire cross-section with TSVI, mm2 | 0,75 — 1 |
Length of the standard sleeve NSVE, mm | 8 (10 for adjusting screwless terminal blocks) |
Torque of screws, N∙m | 0,2 (for screw terminals) |
Connection to the controller
See Activating the modules in the web interface of the controller
Подключение
Датчики/счетчики с импульсными выходами/кнопки.
Такие устройства формируют сигнал, замыкая подходящие к ним два провода. Подключите один провод к клемме GND модуля. Второй провод подключите к клемме Dx. Некоторые счетчики имеют импульсный выход на оптроне, тогда два провода имеют полярность - "плюс" и "минус". В таком случае минус подключается к GND, "плюс" к Dx.
Устройства с выходом открытый коллектор.
Устройство и модуль должны иметь общую землю. Выход "открытый коллектор" подключите к клемме Dx.
Входы модуля гальванически развязаны от контроллера. Поэтому земли GND модуля и контроллера могут быть разными.
Изображения и чертежи устройства
По ссылкам ниже вы можете скачать изображения и чертежи устройства WBIO-DI-DR-8.
Corel Draw 2018: WBIO-DI-DR-8.cdr.zip
Corel Draw PDF: WBIO-DI-DR-8.cdr.pdf
Autocad 2013 DXF: WBIO-DI-DR-8.dxf.zip
Autocad PDF: WBIO-DI-DR-8.pdf