translator, wb_editors
4251
правка
Периферийные устройства с интерфейсом RS-485 серии WB-xxxx/en: различия между версиями
Периферийные устройства с интерфейсом RS-485 серии WB-xxxx/en (просмотреть исходный код)
Версия 15:22, 21 февраля 2023
, 1 год назадНет описания правки
(Новая страница: «== How to install a new Modbus address on our RS-485 device== # Connect the device to the controller, ONLY this device should be connected via the BUS. #: '''If y…») |
Matveevrj (обсуждение | вклад) |
||
| (не показаны 2 промежуточные версии 1 участника) | |||
| Строка 87: | Строка 87: | ||
{| class="wikitable" | {| class="wikitable" | ||
|[[Универсальный датчик WB-MS|WB-MSW v.1, v.2 hybrid sensors in wall-mounted enclosure]] | |[[Универсальный датчик WB-MS|WB-MSW v.1, v.2 hybrid sensors in wall-mounted enclosure]] | ||
| Строка 116: | Строка 115: | ||
|- | |- | ||
|[[WB-MD2_230V_Dimmer| | |[[WB-MD2_230V_Dimmer| | ||
LED and incandescent lamps dimmer WB-MD2] | LED and incandescent lamps dimmer WB-MD2]] | ||
|[[File:WB_MD2_small.png |100px]] | |[[File:WB_MD2_small.png |100px]] | ||
|- | |- | ||
|} | |} | ||
== How to install a new Modbus address on our RS-485 device== | == How to install a new Modbus address on our RS-485 device== | ||
# Connect the device to the controller, ONLY this device should be connected via the BUS. | # Connect the device to the controller, ONLY this device should be connected via the BUS. | ||
#: '''If you connect several devices on the bus, their performance will be disrupted!''' | #: '''If you connect several devices on the bus, their performance will be disrupted!''' | ||
# Run the [[ | # Run the [[SSH | console]] commands: | ||
<syntaxhighlight lang="bash"> | <syntaxhighlight lang="bash"> | ||
service wb-mqtt-serial stop # stop the standard RS-485 driver | service wb-mqtt-serial stop # stop the standard RS-485 driver | ||
| Строка 134: | Строка 132: | ||
== | == Device firmware update == | ||
Starting with the new firmware versions of the device, the firmware update functionality (firmware) via the Modbus Protocol is supported. This makes it possible to extend the functionality of the devices and eliminate errors in the firmware directly at the installation site. Read more about flashing devices described in the article [[WB-MCU-Flasher|Download firmware to Wiren Board devices]]. A list of firmware versions that support the update, as well as devices for which this feature is implemented, can be found in [[Firmware_Changelog]]. | |||