Работа с GPIO/en: различия между версиями

Работа с GPIO/en (просмотреть исходный код)

Версия 17:45, 24 апреля 2019

5 байт убрано , 5 лет назад

Нет описания правки

RomanKulibaba

12 063

правки

Версия 17:43, 24 апреля 2019 (просмотреть исходный код) RomanKulibaba (обсуждение \| вклад) ← Предыдущая правка		Версия 17:45, 24 апреля 2019 (просмотреть исходный код) RomanKulibaba (обсуждение \| вклад) Следующая правка →
Строка 7:		Строка 7:
	In Wiren Board rev. 2.8 8 GPIO are placed on a special connector and connected via [[Special:MyLanguage/MCP23S08\|MCP23S08]] and temporarily do not work with Linux API standard. How to work with them: see page [[Special:MyLanguage/MCP23S08\|MCP23S08]].		In Wiren Board rev. 2.8 8 GPIO are placed on a special connector and connected via [[Special:MyLanguage/MCP23S08\|MCP23S08]] and temporarily do not work with Linux API standard. How to work with them: see page [[Special:MyLanguage/MCP23S08\|MCP23S08]].

	<b> All ~~GPIO~~ (as well as other ports Wiren Board) ~~working~~ with ~~voltage~~ 3.3V. ~~In no case do~~ not connect ~~directly to the GPIO~~ signals with voltage over 3.3V! In case you want to connect devices operating at a higher voltage, you must use matching circuits or ~~connected~~ (for 5V) ~~through~~ a resistor of 20 kOhm or more</b>		<b> All GPIOs (as well as other ports of Wiren Board controllers) work with 3.3V voltage.Do not connect signals with voltage over 3.3V directly to the GPIO! In case you want to connect devices operating at a higher voltage, you must use matching circuits or connect(for 5V) via a resistor of 20 kOhm or more</b>