translator, wb_editors
4200
правок
ADC/en: различия между версиями
Нет описания правки
Matveevrj (обсуждение | вклад) |
Matveevrj (обсуждение | вклад) |
||
| Строка 19: | Строка 19: | ||
=== Connection and setup === | === Connection and setup === | ||
#The voltage must be within the acceptable range. | #The voltage must be within the acceptable range. | ||
#The Ax terminal blocks perform two functions: ADC and low voltage load control. Before measuring voltage, set the corresponding low voltage load control output to the off position. For example, if you are connecting to terminal A1, turn off in [[Веб-интерфейс Wiren Board | web interface]] | #The Ax terminal blocks perform two functions: ADC and low voltage load control. Before measuring voltage, set the corresponding low voltage load control output to the off position. For example, if you are connecting to terminal A1, turn off A1_OUT in [[Веб-интерфейс Wiren Board | web interface]] (section Relays & FETs). | ||
#Connect your source to the Ax terminal. The voltage value will immediately appear in the [[Веб-интерфейс Wiren Board | web interface]] on the ADCs. The value is also translated into the message system [[Special:MyLanguage/MQTT|MQTT]]. | #Connect your source to the Ax terminal. The voltage value will immediately appear in the [[Веб-интерфейс Wiren Board | web interface]] on the ADCs. The value is also translated into the message system [[Special:MyLanguage/MQTT|MQTT]]. | ||
=== Measured voltage display === | === Measured voltage display === | ||