translator, wb_editors
4251
правка
DI/en: различия между версиями
Нет описания правки
Matveevrj (обсуждение | вклад) (Новая страница: «When the channel is in input mode, the Ax_OUT (D1_OUT) switch must be turned off.») |
Matveevrj (обсуждение | вклад) |
||
| (не показаны 3 промежуточные версии этого же участника) | |||
| Строка 8: | Строка 8: | ||
#''Dry contact'' — input for connecting '''dry contact''' (W1, W2 at controller, WB-MR at relay modules, etc.), which check if they are shorted to ground. | #''Dry contact'' — input for connecting '''dry contact''' (W1, W2 at controller, WB-MR at relay modules, etc.), which check if they are shorted to ground. | ||
One contact of the button / reed switch / counter is connected to the ground (to the GND terminal), and the other to the «dry contact» input. You can also connect outputs of the «open collector» type (connect grounds and input to output). | One contact of the button / reed switch / counter is connected to the ground (to the GND terminal), and the other to the «dry contact» input. You can also connect outputs of the «open collector» type (connect grounds and input to output). | ||
Input status: | |||
* closed to ground - «on» | * closed to ground - «on» | ||
* not closed to ground - «off» | * not closed to ground - «off» | ||
| Строка 21: | Строка 21: | ||
Image: WB6_AI_DI.PNG| Wiren Board 6 | Image: WB6_AI_DI.PNG| Wiren Board 6 | ||
Image: WB7_AI_DI.PNG| Wiren Board 7 | Image: WB7_AI_DI.PNG| Wiren Board 7 | ||
Image: WB6.Ax.png| Schematic of the Ax | Image: WB6.Ax.png| Schematic diagram of the input Ax | ||
Image: WB7.D1.png| Schematic of the D1 in Wiren Board 7 | Image: WB7.D1.png| Schematic diagram of the input D1 in Wiren Board 7 | ||
</gallery> | </gallery> | ||
When the channel is in input mode, the Ax_OUT (D1_OUT) switch must be turned off. | When the channel is in input mode, the Ax_OUT (D1_OUT) switch must be turned off. | ||