12 063
правки
Disassembling the controller case/en: различия между версиями
Disassembling the controller case/en (просмотреть исходный код)
Версия 19:50, 28 мая 2019
, 4 года назадНовая страница: «Bend the latch with the rotational movement with a little effort (not to break), while shifting the angle of the lower base to itself, as shown in the figure by t…»
(Новая страница: «The upper part of the controller body is attached to the base on four plastic latches - two on the left and two on the right side. We begin to open the controller…») |
(Новая страница: «Bend the latch with the rotational movement with a little effort (not to break), while shifting the angle of the lower base to itself, as shown in the figure by t…») |
||
| Строка 7: | Строка 7: | ||
The upper part of the controller body is attached to the base on four plastic latches - two on the left and two on the right side. We begin to open the controller case with a latch marked with number "1" in the figure (we start with the latches in the thick part of the body, because in order to open them, you need to make more effort). Use a plastic spatula or screwdriver with a straight slot (the tip can be wrapped with insulation tape or tape, so as not to scratch the plastic case). | The upper part of the controller body is attached to the base on four plastic latches - two on the left and two on the right side. We begin to open the controller case with a latch marked with number "1" in the figure (we start with the latches in the thick part of the body, because in order to open them, you need to make more effort). Use a plastic spatula or screwdriver with a straight slot (the tip can be wrapped with insulation tape or tape, so as not to scratch the plastic case). | ||
Bend the latch with the rotational movement with a little effort (not to break), while shifting the angle of the lower base to itself, as shown in the figure by the arrows. In the same way, open the symmetrical latch, marked with the number "2". The two remaining latches are easily bent by hands to the left and to the right respectively. The lower part of the case is open. | |||
Далее аккуратно извлекаем плату из корпуса, для чего со стороны разъемов внешних модулей плату слегка приподнимаем, а боковую стенку корпуса тянем на себя. Направления показаны на рисунке. Затем вынимаем плату с небольшим усилием, держа ее за края. | Далее аккуратно извлекаем плату из корпуса, для чего со стороны разъемов внешних модулей плату слегка приподнимаем, а боковую стенку корпуса тянем на себя. Направления показаны на рисунке. Затем вынимаем плату с небольшим усилием, держа ее за края. | ||