12 063
правки
Disassembling the controller case/en: различия между версиями
Disassembling the controller case/en (просмотреть исходный код)
Версия 19:50, 28 мая 2019
, 4 года назадНовая страница: «Next, carefully remove the board from the case, which from the connectors of external modules, the Board is slightly raised, and the side wall of the case is pull…»
(Новая страница: «Bend the latch with the rotational movement with a little effort (not to break), while shifting the angle of the lower base to itself, as shown in the figure by t…») |
(Новая страница: «Next, carefully remove the board from the case, which from the connectors of external modules, the Board is slightly raised, and the side wall of the case is pull…») |
||
| Строка 9: | Строка 9: | ||
Bend the latch with the rotational movement with a little effort (not to break), while shifting the angle of the lower base to itself, as shown in the figure by the arrows. In the same way, open the symmetrical latch, marked with the number "2". The two remaining latches are easily bent by hands to the left and to the right respectively. The lower part of the case is open. | Bend the latch with the rotational movement with a little effort (not to break), while shifting the angle of the lower base to itself, as shown in the figure by the arrows. In the same way, open the symmetrical latch, marked with the number "2". The two remaining latches are easily bent by hands to the left and to the right respectively. The lower part of the case is open. | ||
Next, carefully remove the board from the case, which from the connectors of external modules, the Board is slightly raised, and the side wall of the case is pulled over. The directions are shown in the figure. Then take out the Board with a little effort, holding it by the edges. | |||
Сборка производится в обратном порядке. Обратите внимание: проточка в нижней части корпуса должна располагаться со стороны разъема SIM-карты. Все защелки должны закрываться со щелчком. | Сборка производится в обратном порядке. Обратите внимание: проточка в нижней части корпуса должна располагаться со стороны разъема SIM-карты. Все защелки должны закрываться со щелчком. | ||
<br /><br /><br /><br /><br /><br /><br /><br /><br /><br /> | <br /><br /><br /><br /><br /><br /><br /><br /><br /><br /> | ||