3688
правок
Firmware Changelog: различия между версиями
Нет описания правки
Метка: visualeditor |
Метка: visualeditor |
||
| Строка 6: | Строка 6: | ||
!Affected devices | !Affected devices | ||
!Changelog | !Changelog | ||
|- | |||
|WB-MR | |||
|2019-02-14 | |||
|1.9.4 | |||
|WB-MR*, WB-MWAC | |||
|* change: fix change modbus id via broadcast 0 address | |||
|- | |||
|WB-MR | |||
|2018-11-14 | |||
|1.9.2 | |||
|WB-MR*, WB-MWAC | |||
|Add check valid for readed from eeprom settings | |||
Add check valid for modbus address when changed via modbus and when readed from eeprom | |||
|- | |||
|WB-MR | |||
|2018-11-14 | |||
|1.9.1 | |||
|WB-MR*, WB-MWAC | |||
| | |||
* more robust configuration storage in EEPROM | |||
* change: I2C EEPROM ic is used to store basic configuration. * added: new input-output relationship handling is implemented: there is a new input mode which tells the fw to use so called input mappings to decide what to do on input state change. This mapping, distinct for each input-output pair, allows to set actions for both rising and falling edges of input signal. The actions are: set output, reset output, toggle output, do nothing. * change: Kill-switch function is basically removed. It replaced with simplified input mode 2 which switches off all output channels on rising edge of the signal. * added: WB-MWAC water leak controller is supported | |||
|- | |- | ||
|WB-MRGB | |WB-MRGB | ||