100
правок
Firmware Changelog: различия между версиями
→Общая таблица по всем устройствам/ Summary table for all devices
N.kulikov (обсуждение | вклад) |
|||
| Строка 16: | Строка 16: | ||
| | | | ||
| | | | ||
|- | |||
|WB-MS | |||
|28-09-2020 | |||
|[http://fw-releases.wirenboard.com/?prefix=fw/by-version/WB-MS/stable/4.15.0/ 4.15.0] | |||
|ALL | |||
| | |||
* Improve input voltage measure and powerdown handle | |||
* Increase software I2C speed to 50 kHz for faster EEPROM writing | |||
* Fixed modbus frame borders detection | |||
* Added holding register 113 to set modbus inter frame timeout | |||
* Rework hdc1080, opt3001, sgpc3 modules with new non blocking i2c library | |||
* Added MSW v3 rev 4.9 target with mems mic and additional highgain adc input channel | |||
* Removed SPL linear approximation calculation. All targets use response tables | |||
* Changed digital input counter saving to EEPROM algorithm for devices with digital inputs. Previously counters data was loaded to EEPROM once per 600 sec. Now if counter increments slower than 1 time per 300s, the data uploads in EEPROM for each change, otherwise, not faster than 1 time per 300s. | |||
|- | |||
|WB-MS | |||
|14-09-2020 | |||
|[http://fw-releases.wirenboard.com/?prefix=fw/by-version/WB-MS/stable/4.14.1/ 4.14.1] | |||
|ALL | |||
|Reduce 1wire sensors initialization time. | |||
|- | |- | ||
|WB-MR | |WB-MR | ||
|02-09-2020 | |02-09-2020 | ||
|[http://fw-releases.wirenboard.com/?prefix=fw/by-version/WB-MR/stable/1.15.1/ 1.15.1] | |[http://fw-releases.wirenboard.com/?prefix=fw/by-version/WB-MR/stable/1.15.1/ 1.15.1] | ||
| | |WB-MIR WB-M1W2 WB-MSv2 | ||
|Improve input voltage measure and powerdown handle. | |Improve input voltage measure and powerdown handle. | ||
|- | |- | ||