Gas sensor WB-MSGR/en: различия между версиями

Новая страница: «Temperature and humidity also affect the resistance of the sensing element: it drops with increasing temperature and humidity.»
(Новая страница: «There is a heater inside the sensor, which is constantly switched on, which makes it possible to measure the concentration of gases. If the sensor remained de-ene…»)
(Новая страница: «Temperature and humidity also affect the resistance of the sensing element: it drops with increasing temperature and humidity.»)
Строка 138: Строка 138:
There is a heater inside the sensor, which is constantly switched on, which makes it possible to measure the concentration of gases. If the sensor remained de-energized for a long time, then the output to the operating mode will require some time: from two days, if the sensor was not turned on for a month, to a week, if the sensor was not turned on for more than six months. Operation in an aggressive environment leads to degradation of SE, ice and condensate reduce its sensitivity.  
There is a heater inside the sensor, which is constantly switched on, which makes it possible to measure the concentration of gases. If the sensor remained de-energized for a long time, then the output to the operating mode will require some time: from two days, if the sensor was not turned on for a month, to a week, if the sensor was not turned on for more than six months. Operation in an aggressive environment leads to degradation of SE, ice and condensate reduce its sensitivity.  


Температура и влажность также влияют на сопротивление чувствительного элемента: оно падает с увеличением температуры и влажности.  
Temperature and humidity also affect the resistance of the sensing element: it drops with increasing temperature and humidity.  


Перед настройкой датчика дождитесь выхода ЧЭ на рабочий режим (так называемый "отжиг"). О выходе на рабочий режим можно судить по стабилизации сопротивления ЧЭ при неизменных окружающих условиях — при которых датчик будет постоянно эксплуатироваться.
Перед настройкой датчика дождитесь выхода ЧЭ на рабочий режим (так называемый "отжиг"). О выходе на рабочий режим можно судить по стабилизации сопротивления ЧЭ при неизменных окружающих условиях — при которых датчик будет постоянно эксплуатироваться.
12 063

правки