История
24 апреля 2020
Нет описания правки
+34
Нет описания правки
+6
Нет описания правки
−40
Нет описания правки
+6
Нет описания правки
+6
Нет описания правки
+3
Нет описания правки
+6
Нет описания правки
+10
Нет описания правки
+38
Новая страница: «Starting from firmware v.1.9.0, mode 2 is also provided for individual channels-disable all outputs, and operating modes (4 and 5) in accordance with the mapping…»
−482
Новая страница: «Mapping-matrix»
−18
Новая страница: «There could be no registers 9 etc. in outdated firmware. You can only set mode for all their channels at once. To do so, write corresponding number to holding reg…»
−142
Нет описания правки
−172
Новая страница: «The mode set separately for each channel. To select mode, write mode number to corresponding holding register, starting with register 9 for the first channel etc.…»
−56
Нет описания правки
−381
Новая страница: «You can enable direct control of the relay outputs from the digital inputs in the relay module. There are several options for such management: Simple:…»
−254
Новая страница: «Modes of interaction between digital inputs and relay outputs»
−58
Новая страница: «The input state can be obtained by reading the Discrete Inputs 0—x registers (where x = (number of managed channels - 1)). If the input is connected to GND, the…»
−121
Новая страница: «Digital inputs»
−22
Новая страница: «In the latest firmware versions (starting with 1.5.3) for WB-MR devices, it is now possible to remember the output status when power is off. The mode is controlle…»
−339
Новая страница: «Relay operation in case of power failure»
−52
Новая страница: «To enable Safety timer, you must write a value other than 0 to the storage register with the WRITE_SINGLE_REGISTER command at 8. This value is a timeout in second…»
−184
Нет описания правки
−201
Новая страница: «In this mode, when the Modbus communication is terminated, the device disconnects the relay after a specified time. To enable Safety timer, you must write a valu…»
+112
Новая страница: «Device Setup»
−27
Новая страница: «Device Setup»
+5225