SIM68V/en: различия между версиями

Новая страница: «<b>In Wiren Board controller rev. 2.8 the external active antenna is not powered off when the module is put into power saving mode. To power off the external acti…»
(Новая страница: «<b>161 PMTK_CMD_STANDBY_MODE</b> command. Deactivates the module to reduce power consumption. To activate the module, send any byte to the port.»)
(Новая страница: «<b>In Wiren Board controller rev. 2.8 the external active antenna is not powered off when the module is put into power saving mode. To power off the external acti…»)
Строка 65: Строка 65:
</pre>
</pre>


<b>В Wiren Board rev. 2.8 питание внешней активной антенны не отключается при переводе модуля в режим энергосбережения. Для отключения питания внешней активной антенны необходимо отключить всю шину питания 3.</b>.
<b>In Wiren Board controller rev. 2.8 the external active antenna is not powered off when the module is put into power saving mode. To power off the external active antenna, the entire 3.3 V power bus must be disconnected.</b>.




12 063

правки