История
3 июня 2019
30 мая 2019
Новая страница: «If you receive an error while reading from register 112, the device does not support setting communication parameters. In this case,the default value of 2 stop bi…»
−175
Новая страница: «or»
−4
Новая страница: «For stop bits, you will likely get two values: 1 and 2. You can refine the setting by reading the value from the register 112 with the already known address, spee…»
−123
Новая страница: «In this script we refer to the 0x80 register, which stores the modbus address in all Wiren Board Modbus devices. The output of the scr…»
−136
Новая страница: «In this case, a paradoxical situation arises: we can not know the value of the speed, if we do not specify its value in advance when referring to the device! Ther…»
−348
Новая страница: «Writing to the appropriate registers changes the parity and the number of stop bits.»
−64
Новая страница: «The device now transmits and receives data at 115200 bps.»
−68
Новая страница: «You can write a new value by using the following command:»
−51
Новая страница: «For details, see the description of the modbus_client command. '''Important: the examples below use the /dev/ttyAPP1 port. If the device is c…»
−143
Новая страница: «You can find out the current settings of the data exchange parameters by reading the value of the above registers, for example:»
−81
Нет описания правки
−25
Нет описания правки
−2
29 мая 2019
Новая страница: «To be able to access the device that supports the modbus RTU Protocol over the RS-485 bus, it is necessary to know its modbus address, as well as the data exchang…»
−233
Новая страница: «== Changing data exchange settings ==»
−36
Новая страница: «{| border="1" class="wikitable" style="text-align:center; width:1000px;" !Register / address !Type !Read/write !Value by default !Format !Function |- | 110 || h…»
−267
Новая страница: «RS-485 data exchange parameters registers In the factory configuration, all Wiren Board devices are supplied with the following RS-485 settings: 9600 bps, no pari…»
−226
Новая страница: «== RS-485 data exchange parameters registers ==»
−35
Новая страница: «UART Communication Settings»
+6202