История
15 января 2016
Новая страница: «Special current inputs in the WB absent but it is possible, using a resistor Rx = 100-300Om, the current is converted into a voltage and connect as in the previous.»
−97
Новая страница: «thumb|400px|Example of connection sensor with current output»
−35
Новая страница: «== Sensors with analog current output ==»
−34
Новая страница: «Connect the device to a terminal GND or to a common ground. The sensor output is connected to one of the terminals Ax or Rx. Channels Ax / Rx have different range…»
−204
Новая страница: «Example: temperature sensors.»
−27
Новая страница: «== Sensors with analog voltage output ==»
−45
Новая страница: «Also for low-voltage load switching, you can use digital output module (WBIO-DO-HS-8), see. Modules IO.»
−148
Новая страница: «When switching inductive loads (relay), there are voltage spikes. For overvoltage protection controller integrated protective diodes - external protective element…»
−160
Новая страница: «Connect '+' load to "+" power supply, and "-" to terminal Ax. If the total current per channel over 2 A connect GND terminal to the "-" power supply.»
−144
Новая страница: «Examples: 12/24V relay , LED, fans, signal lamps and so on.»
−67
Новая страница: «thumb|400px|Example of connecting relays»
−16
Новая страница: «== Switching low-voltage load ==»
−40
Новая страница: «Wiren Board 5: Connection of peripheral devices»
+8484