История
1 июля 2019
Нет описания правки
+7
Новая страница: «{| class="wikitable" !Controller !Revision !MOD1 !MOD2 !Purchase part number |- |Wiren Board 5 |5.3 |<nowiki>+</nowiki> |<nowiki>-</nowiki> |WBE-MICROSD |- |Wiren…»
−30
Новая страница: «== Compatibility table ==»
−22
Новая страница: «The memory card is defined in the system as mmc1. The entire card is available as /dev/mmcblk1 is the card partitions as /dev/mmcblk1p0 etc.»
−79
Новая страница: «== Operation ==»
−3
Новая страница: «The device is detected immediately, no reboot is required.»
−54
Новая страница: «For rev.5.6 - "WBE-MICROSD: microSD module (WB 5.6)".»
−32
Новая страница: «Для аппаратной нужно выбрать "WBE-MICROSD: microSD module". For the hardware WB Wiren Board 5: Аппаратные ревизии/en…»
+51
Новая страница: «Configuration is done in the web interface. Section Configs => Hardware Modules Configuration. Next, in Internal slot 1 select "WBE-MICROSD" and click Save.»
−58
Новая страница: «thumb|300px|Configuration»
−11
Новая страница: «==Configuration==»
−22
Новая страница: «O1-O3 terminals are not used.»
−26
Новая страница: «== Pinout ==»
−14
Новая страница: «Supported cards: microSD, microSDHC. Maximum interface speed supported: "high speed" (18MB/s for revision 5.3, 4.5 MB/s for revision 5.6). Standard UHS is not su…»
−137
Новая страница: «the microSD card is inserted into the slot under the top cover of the controller. The module comes without a microSD card!»
−69
Новая страница: «Can be installed only to MOD1 extension slot.»
−16
Новая страница: «== Hardware ==»
−23
Новая страница: «__NOTOC__ thumb|300px| MicroSD extension module»
−16
Новая страница: «{{DISPLAYTITLE:MicroSD extension module (WBE-MICROSD)}}»
+2202