Wiren Board 6: WBE2S-MICROSD Extension Module

Материал из Wiren Board
Версия от 15:56, 22 апреля 2021; FuzzyBot (обсуждение | вклад) (FuzzyBot переименовал страницу Wiren Board 6: WBE2S-MICROSD Extension Module/en в WBE2S-MICROSD MicroSD Extension Module/en без оставления перенаправления: Часть переводимой страницы Wiren Board 6: WBE2S-MICROSD Extension Module.)

(разн.) ← Предыдущая | Подтверждённая версия (разн.) | Текущая версия (разн.) | Следующая → (разн.)
Другие языки:

Hardware

WBE2S-MICROSD back side
WBE2S-MICROSD front side

Can be installed only in MOD3 slot of the Wiren Board 6 controller.

the microSD card is inserted into the slot under the top cover of the controller.

To access the connector, pry the cover off with a flat screwdriver and remove it.

The module comes without a microSD card!

Supported cards: microSD, microSDHC. Maximum interface speed supported: "high speed" (18MB/s for revision 5.3, 4.5 MB/s for revision 5.6). Standard UHS is not supported (card is working in the mode of "high speed").


Configuration

Configuration

Configuration is done in the web interface. Section Configs => Hardware Modules Configuration. Next, in Internal slot 3 select "WBE3-MICROSD: microSD module" and click Save.

The device is detected immediately, no reboot is required.


Operation

The memory card is defined in the system as mmc1. The entire card is available as /dev/mmcblk1 is the card partitions as /dev/mmcblk1p0 etc.