История
27 июня 2019
Новая страница: «Scheduled for correction in devices shipped after 10.2016.»
−64
Новая страница: «====Scheduled fix===»
−41
Новая страница: «* Send the device for warranty repair»
−45
Новая страница: «* (preferred) do not connect PSU to A1-A4 inputs directly, connect via resistor in 1-10kω. With this resistance, the digital and analog inputs will work, but swi…»
−224
Новая страница: «====Workarounds====»
−10
Новая страница: «The gate of the transistor at the output of A4 is incorrectly tightened.»
−25
Новая страница: «====Reasons and detailed description====»
−21
Новая страница: «When the controller is turned on, the A4 output may be in the open or semi-open state. If a power supply is directly connected to the A4 terminal block (the termi…»
−226
Новая страница: «====Description====»
−5
Новая страница: «Wiren Board 5 rev. 5.3, 5.6, Wiren Board 5:…»
+9
Новая страница: «==== Affected devices ====»
−27
Новая страница: «== 0530003: Undefined A4 output state ==»
−38
Новая страница: «Fixed in rev. 5.6.»
−22
Новая страница: «====Scheduled fix===»
−41
Новая страница: «no»
−4
Новая страница: «====Workarounds====»
−10
Новая страница: «See 053001 above.»
−5
Новая страница: «====Reasons and detailed description====»
−21
Новая страница: «The left led (ACT) on the Ethernet connector does not work.»
−28
Новая страница: «====Description====»
−5
Новая страница: «Wiren Board 5 rev. 5.3, shipped after 20.03.2016»
−17
Новая страница: «==== Affected devices ====»
−27
Новая страница: «== 0530002: the ACT led on the Ethernet connector does not work ==»
−22
Новая страница: «Fixed in revisions 5.6.»
−37
Новая страница: «====Scheduled fix===»
−41
Новая страница: «It is recommended to use the watchdog daemon to check the network availability.»
−39
Новая страница: «The software fix is to run ifdown eth0 ; ifup eth0 or ifconfig eth0 down ; ifconfig eth0 up to reinitialize the interface.»
−95
Новая страница: «The hardware fix is to solder the R83 resistor on the back of the Board under the Ethernet connector.»
−86
Новая страница: «====Workarounds====»
−10
Новая страница: «The ACT led is used in the PHY to set PHY mode. Incorrect connection of the led in the circuit makes the levels setting the PHY mode random.»
−123
Новая страница: «====Reasons and detailed description====»
−21
Новая страница: «Sometimes, when you turn on the Ethernet controller, it is in a non-working state. Traffic does not go in both directions, despite the presence of the link. The g…»
−101
Новая страница: «====Description====»
−5
Новая страница: « Wiren Board 5 rev. 5.3»
+3
Новая страница: «==== Affected devices ====»
−27
Нет описания правки
−3
Новая страница: «= = = 0530001: Ethernet Problems ==»
−23
Новая страница: «WB 5: Errata»
+4154