12 063
правки
WB SH 3.5: GPIO List/en: различия между версиями
Новая страница: «{| class="wikitable" |"'Controller"' |"'Linux port name'" |"'Connector on controller'" |'''Note''' |- | rowspan="2" |Wiren Board Smart Home 3.5/en |"/dev/ttyN…»
(Новая страница: «=== RS-485 ports execution===») |
(Новая страница: «{| class="wikitable" |"'Controller"' |"'Linux port name'" |"'Connector on controller'" |'''Note''' |- | rowspan="2" |Wiren Board Smart Home 3.5/en |"/dev/ttyN…») |
||
| Строка 4: | Строка 4: | ||
{| class="wikitable" | {| class="wikitable" | ||
|' | |"'Controller"' | ||
|' | |"'Linux port name'" | ||
|'' | |"'Connector on controller'" | ||
|''' | |'''Note''' | ||
|- | |- | ||
| rowspan="2" |[[Wiren Board Smart Home 3.5]] | | rowspan="2" |[[Wiren Board Smart Home 3.5/en]] | ||
| | |"/dev/ttyNSC0" | ||
| | |Green terminal pair | ||
| rowspan="2" |[[Файл:Перемычки.png|thumb|200px| | | rowspan="2" |[[Файл:Перемычки.png|thumb|200px|Jumper terminators in Wiren Board Smart Home 3.5]] half-Duplex ports. Transceivers are connected to the chip [[SC16IS752/en]]. <br> terminators between lines A and B are installed On the Board, they can be turned off by unsoldering the jumpers (by default they are soldered) - see photos | ||
|- | |- | ||
| | |"/dev/ttyNSC1" | ||
| | |Blue pair of terminals | ||
|- | |- | ||
|} | |} | ||