История
1 июля 2021
18 июля 2019
11 июня 2019
Новая страница: «Red indicators DO 1-8 indicate the presence of a logical 1 on the corresponding digital output, and DI 1-8 — on the corresponding digital input.»
−127
Новая страница: «===Power/Data status light=== The Power/Data status light is green when power is supplied,it is blinking when data is received and sent, or it is red when an erro…»
−112
Новая страница: «===Modbus Registers=== *Discrete Input registers '''0x00-0x07''' allow you to read the state of digital inputs. *Coil registers '''0x00-0x07''' allow you to reco…»
−195
Новая страница: « The digital inputs are galvanically isolated via the optocoupler; a button or switch is connected to the DIx pin and to the "-" of the main power supply of the…»
−91
Новая страница: «The digital outputs are protected by a diode and allow switching relays or indicators connected to the DO and "+" pin of the main power supply.»
−108
Новая страница: «*AVcc — "+" power supply module *AGnd — "-" module power *485A — line A RS485 (+) *485B — line A RS485 (+) *DI_0'''1-8''' — digital inputs *DO_0'''1-8''…»
−72
Новая страница: «===Pin assignment===»
−21
Новая страница: «===Technical parameters=== *Digital inputs — active level low *Digital outputs — NPN-open collector transistor output, 500mA *Operating temperature— -20-70…»
−221
Новая страница: «The WP8028ADAM I/O module has 8 digital inputs and 8 digital outputs. thumb | 200px| Wellpro WP8028ADAM»
−59
Новая страница: «The red lights DI 1-4 (four to the left) indicate the presence of a logical 1 at the corresponding digital input and DO 1-4 (four to the right) lights - at the…»
−135
Новая страница: «===Power/Data status light=== The Power/Data status light is green when power is supplied,it is blinking when data is received and sent, or it is red when an erro…»
−112
Новая страница: «===Modbus registers=== *Holding registers 0x00-0x05 contain the values of the analog signal being read. The current in milliamperes is calculated by the formula I…»
−277
Новая страница: «The digital inputs are galvanically isolated via the optocoupler; a button or switch is connected to the DIx pin and the "-" main power supply of the module.»
−103
Новая страница: «The digital outputs are protected by a diode and allow switching of relays or indicators connected to the DO_x and "+" pin of the main power supply.»
−105
Новая страница: «The analog outputs allow three — wire sensors to be connected- in this case the sensor is connected to the Gnd and the sensor power supply - " + " sensor to the…»
−266
Новая страница: «*AVcc — "+" power supply module *AGnd — "-" module power *485A — line A RS485 (+) *485B — line A RS485 (+) *DI_1-4 — digital inputs *DO_1-4 — digital…»
−166
Новая страница: «===Pin assignment===»
−21
Новая страница: «===Technical parameters=== *Analog inputs — 0-20 ± 2 mA DC *Digital inputs — active level low *Digital outputs — NPN-open collector transistor output, 500m…»
−272
Новая страница: «==Wellpro WP9038ADAM== The WP9038ADAM I / o module has 4 digital inputs, 4 digital outputs and 6 analog inputs. Файл:9038.png|thumb | 200px| Wellpro WP9038A…»
−73
Новая страница: «''' Negative temperature values are not supported by the current version of the Wirenboard template!'''»
−60
Новая страница: « The temperature is determined as follows: *DATA > 10000 — temperature below 0°C, TEMP =-(DATA-10000)/10 *DATA < 10000, the measured temperature exceeds 0°C,…»
−85
Новая страница: «===Modbus Registers=== Storage registers (Holding registers) 0x00-0x07 contain temperature information received from the sensor. A 0xFFFF value read from the regi…»
−125
Новая страница: «*AVcc — "+" power supply module *AGnd — "-" module power *485A — line A RS485 (+) *485B — line A RS485 (+) *Vdd — +5V for power supply to DS18B20 sensor…»
−91
Новая страница: «===Pin assignment===»
−21
Новая страница: «*Operating temperature— -20-70°C *Power — external DC power supply 9V — 30V *Power consumption — 2 W»
−117
Новая страница: «==Technical specifications==»
−29
Новая страница: «The Wellpro WP3066ADAM is a data acquisition module for DS18B20 temperature sensors. Up to 8 sensors can be connected to the module. Файл:3066.png|thumb | 2…»
−110
Новая страница: «===Power/Data status light=== The Power/Data status light is green when power is supplied,it is blinking when data is received and sent, or it is red when an erro…»
−121
Новая страница: «Register '''0x65''' stores communication parameters. After recording, you may need to restart. {| class="wikitable" !Value !Speed !Parameters |- |0x0001 |4800 |8N…»
−115
Новая страница: «===Modbus registers=== The address is written to '''0x64''' register ,address 0x00 with a single device on the bus.»
−85
Нет описания правки
−2
Новая страница: «===Коммуникационные параметры по умолчанию=== * Разрядность — 8 бит * Стоп-бит — 1 * Проверка…»
+117
Новая страница: «==Technical parameters== Wellpro Adam series devices support Modbus RTU Protocol over RS-485 bus. The devices are mounted on a 35 mm DIN rail or screwed on top of…»
−209
Обновление для соответствия новой версии исходной страницы.
−12
Новая страница: « Wellpro devices»
+9631