12 063
правки
(не показано 5 промежуточных версий 2 участников) | |||
Строка 185: | Строка 185: | ||
|- | |- | ||
{|} | {|} | ||
== Input protection == | == Input protection == | ||
Строка 203: | Строка 200: | ||
== Multifunctional inputs/outputs Ax and Dx == | == Multifunctional inputs/outputs Ax and Dx == | ||
[[File:Ax.png|thumb|400px| Equivalent | [[File:Ax.png|thumb|400px| Equivalent circuit of A1-A3 channels]] | ||
[[File:А5.png|thumb|400px|Equivalent | [[File:А5.png|thumb|400px|Equivalent circuit of A4-A5 channels]] | ||
[[File:Dx.png|thumb|400px|Equivalent channels | [[File:Dx.png|thumb|400px|Equivalent circuit of Dx channels]] | ||
Multifunctional channels consist of input and output stages are connected in parallel, as well as protective diodes (connected to one terminal of the channel). | Multifunctional channels consist of input and output stages are connected in parallel, as well as protective diodes (connected to one terminal of the channel). | ||
Строка 213: | Строка 211: | ||
The state of the switch is controlled by logic circuits inside the controller. The switch may be one of 2 states: | The state of the switch is controlled by logic circuits inside the controller. The switch may be one of 2 states: | ||
*Active (closed); | *Active (closed); channel output is connected to ground (0V) | ||
*Inactive (open), high impedance. | *Inactive (open), high impedance. | ||
Such outputs are called “open collectors”. | Such outputs are called “open collectors”. | ||
Input stage of Ax channel consists of an analogue-to-digital converter ADCx and an input resistor Rx. | Input stage of Ax channel consists of an analogue-to-digital converter ADCx and an input resistor Rx. | ||
The ADC has a high impedance, so it doesn't affect the channel operation even if the channel works as output. | |||
In input mode the Tx switch is inactive (open) and, thus, does not affect voltage measuring at the channel terminals. Input resistance of the channel in input mode is determined by the Rx resistance. | |||
If the channel terminal is left floating, the input voltage measured by ADCs is pulled down to zero by the Rx resistance. | |||
А4 and А5 support binary input function DI: more than 3V at the terminal is considered as triggering of the input. | А4 and А5 support binary input function DI: more than 3V at the terminal is considered as triggering of the input. | ||
Строка 392: | Строка 397: | ||
=== Example of device connection === | === Example of device connection === | ||
Schematic test stand - [[Файл:Стенд-hi.jpg|thumb|500px|Schematic test stand]] | |||
== | == Schematics and Drawing == | ||
Wiren Board 4 principle diagram - [[Файл:WB 4.3.pdf|Файл:WB 4.3.pdf]], scheme - [[Файл:WB 4.2 чертеж.pdf|Файл:WB 4.2 чертеж.pdf]] | Wiren Board 4 principle diagram - [[Файл:WB 4.3.pdf|Файл:WB 4.3.pdf]], scheme - [[Файл:WB 4.2 чертеж.pdf|Файл:WB 4.2 чертеж.pdf]] |
правки