12 063
правки
Wiren Board 6: Hardware/en: различия между версиями
Новая страница: «== +5 Vout power output == It is convenient to use +5V output to power the sensors. It is protected from short circuit and high voltage. When the controller is po…»
(Новая страница: «Wx can be used to connect discrete sensors. Wx channels are equipped with tightening to +5 V. Dry contact type inputs are connected between ground and Wx. The Wx…») |
(Новая страница: «== +5 Vout power output == It is convenient to use +5V output to power the sensors. It is protected from short circuit and high voltage. When the controller is po…») |
||
| Строка 34: | Строка 34: | ||
Wx can be used to connect discrete sensors. Wx channels are equipped with tightening to +5 V. Dry contact type inputs are connected between ground and Wx. The Wx output mode is set by the W1 terminal mode (W2 terminal mode) parameter: '''1-Wire master''' or '''Discrete input''' in the ''Hardware Modules Configuration'' of the web interface. | Wx can be used to connect discrete sensors. Wx channels are equipped with tightening to +5 V. Dry contact type inputs are connected between ground and Wx. The Wx output mode is set by the W1 terminal mode (W2 terminal mode) parameter: '''1-Wire master''' or '''Discrete input''' in the ''Hardware Modules Configuration'' of the web interface. | ||
== | == +5 Vout power output == | ||
It is convenient to use +5V output to power the sensors. It is protected from short circuit and high voltage. When the controller is powered by a battery, the +5V output remains active. There is also a function of software control of this output — it can be disabled. In the Web interface the output control is realised through the 5V_OUT of the Discrete I/O device. The voltage of the channel is measured by the ADC. | |||
== Выход питания Vout == | == Выход питания Vout == | ||