wb_editors
14 457
правок
(Новая страница: «Connection parameters: 9600 8N1.») |
FuzzyBot (обсуждение | вклад) м (FuzzyBot переименовал страницу Wiren Board 6: WBE2R-R-GPS GPS/GLONASS Extension Module/en в WBE2R-R-GPS GPS/GLONASS Extension Module/en без оставления перенаправления: Часть переводимой страницы Wiren Board 6: WBE2R-R-GPS GPS/GLONASS Extension Module.) Метки: правка с мобильного устройства правка из мобильной версии |
||
(не показано 10 промежуточных версий 1 участника) | |||
Строка 1: | Строка 1: | ||
<languages/> | <languages/> | ||
{{ | <!-- {{DISPLAYTITLE:Wiren Board 6: Модуль расширения GPS/Glonass (WBE3-R-GPS)}} --> | ||
Module comes with GPS/Glonass module SIM68M. | Module comes with GPS/Glonass module SIM68M. | ||
Строка 27: | Строка 27: | ||
Connection parameters: 9600 8N1. | Connection parameters: 9600 8N1. | ||
The PPS signal is output to the "CS" input of the extension connector. | |||
== | == Operation in Wiren Board 6 == | ||
{| class="wikitable" | {| class="wikitable" | ||
! | !Extension module | ||
! | !Serial port | ||
|- | |- | ||
|MOD3 | |MOD3 | ||
Строка 39: | Строка 39: | ||
|} | |} | ||
== | == Module installation == | ||
Installation of the module is possible in any of the MOD1-3 internal slots. The procedure for installing the module into the controller is shown on page[[Wiren Board 5: Модуль расширения GPS/Glonass#Установка модуля/en| GPS/GLONASS module installation]] ( similar to the WB5) | |||
== | == Add a module to the Web interface == | ||
[[File:Wbe3-r-gps_configuration.png|500px|thumb|left| | [[File:Wbe3-r-gps_configuration.png|500px|thumb|left|Configuring the module in the Web interface]] | ||
[[File:NMEA_messages.png|500px|thumb|right| | [[File:NMEA_messages.png|500px|thumb|right|NMEA message output]] | ||
In the Web interface section'''Configs''' '''=>''' '''Hardware Modules Configuration''' in the list of expansion slots, select the slot in which you installed the module, for example, '''Internal slot 3''', and in the list '''Module type''' select '''WBE3-R-GPS: GPS/GLONASS Receiver'''. Press '''Save''' to add a module to the controller configuration. | |||
You can check the presence of the module by the output of the dmesg command, it should appear lines like: | |||
<pre> | <pre> | ||
[ 380.797627] pps pps2: new PPS source mod3_pps.-1 | [ 380.797627] pps pps2: new PPS source mod3_pps.-1 | ||
Строка 54: | Строка 54: | ||
</pre> | </pre> | ||
The output of the lsmod command must specify the pps_gpio module, and the output of NMEA messages can be obtained with the command <code>cat/dev/ttyMOD3</code> (see Fig.) |