12 063
правки
WB-MSx Consumer IR Manual/en: различия между версиями
Новая страница: «==== Signal record in ROM with the remote control ==== '''Note:''' For more about work in command line mode, see the section #Control module from the command li…»
(Новая страница: «== Constant mode == In constant mode, the IR commands are stored in the device memory and are available after a power reset. Each command is stored in a separate…») |
(Новая страница: «==== Signal record in ROM with the remote control ==== '''Note:''' For more about work in command line mode, see the section #Control module from the command li…») |
||
| Строка 41: | Строка 41: | ||
In constant mode, the IR commands are stored in the device memory and are available after a power reset. Each command is stored in a separate "Bank" of memory. The number of memory banks depends on the device flashing. Prior to firmware 3.7.2 inclusive, the devices had 7 memory banks of IR commands. Starting with version 4.4.0 32 banks are supported. Intermediate versions allowed to record up to 80 commands, but in some cases did it incorrectly. | In constant mode, the IR commands are stored in the device memory and are available after a power reset. Each command is stored in a separate "Bank" of memory. The number of memory banks depends on the device flashing. Prior to firmware 3.7.2 inclusive, the devices had 7 memory banks of IR commands. Starting with version 4.4.0 32 banks are supported. Intermediate versions allowed to record up to 80 commands, but in some cases did it incorrectly. | ||
==== | ==== Signal record in ROM with the remote control ==== | ||
''' | '''Note:''' For more about work in command line mode, see the section [[#Control module from the command line|Control module from the command line]]. | ||
Чтобы записать сигнал под номером <code>i</code> с пульта ДУ в память, запишите 1 в регистр флагов по адресу <code>5300 + i</code>. Затем направьте пульт ДУ на ИК-приёмник и нажмите кнопку на пульте. После отпускания кнопки, завершите запись сигнала, записав 0 в регистр флагов по адресу <code>5300 + i</code>. | Чтобы записать сигнал под номером <code>i</code> с пульта ДУ в память, запишите 1 в регистр флагов по адресу <code>5300 + i</code>. Затем направьте пульт ДУ на ИК-приёмник и нажмите кнопку на пульте. После отпускания кнопки, завершите запись сигнала, записав 0 в регистр флагов по адресу <code>5300 + i</code>. | ||