12 063
правки
WB-MSW v.3 Modbus Sensor/en: различия между версиями
Новая страница: «Module connection to RS-485 process is described RS-485:Физическое_подключение/en / here in detail.»
(Новая страница: «The screw terminal block of the module is located on its back side and is used to connect power lines (V+ and GND) and control over RS-485 (RS-485 A and B). When…») |
(Новая страница: «Module connection to RS-485 process is described RS-485:Физическое_подключение/en / here in detail.») |
||
| Строка 201: | Строка 201: | ||
The screw terminal block of the module is located on its back side and is used to connect power lines (V+ and GND) and control over RS-485 (RS-485 A and B). When using type handpieces for installation of wires in screw clamps, it is necessary that the diameter of the insulated cuffs does not exceed 3.6 mm, the wire section — 0.75 mm<sup>2</sup>, and the length of the conductive sleeve — 6 mm. Screw clamps also accept wire section up to 1.5 mm<sup>2</sup>. | The screw terminal block of the module is located on its back side and is used to connect power lines (V+ and GND) and control over RS-485 (RS-485 A and B). When using type handpieces for installation of wires in screw clamps, it is necessary that the diameter of the insulated cuffs does not exceed 3.6 mm, the wire section — 0.75 mm<sup>2</sup>, and the length of the conductive sleeve — 6 mm. Screw clamps also accept wire section up to 1.5 mm<sup>2</sup>. | ||
Module connection to RS-485 process is described [[RS-485:Физическое_подключение/en / here]] in detail. | |||
Модуль должен эксплуатироваться при рекомендованных условиях окружающей среды. | Модуль должен эксплуатироваться при рекомендованных условиях окружающей среды. | ||