translator, wb_editors
4251
правка
Disassembling the controller case/en: различия между версиями
Disassembling the controller case/en (просмотреть исходный код)
Версия 20:13, 17 августа 2022
, 1 год назадНет описания правки
Matveevrj (обсуждение | вклад) |
Matveevrj (обсуждение | вклад) |
||
| Строка 8: | Строка 8: | ||
To disassemble the controller, you need to remove the back cover, which is attached to the controller with four latches, and extract a circuit board of controller from the case: | To disassemble the controller, you need to remove the back cover, which is attached to the controller with four latches, and extract a circuit board of controller from the case: | ||
# Put the back cover | # Put the controller back cover up. | ||
# Insert a screwdriver between the latch and the foundation. With a smooth twisting motion, release the latch and pull the back cover up. Do the same with | # Insert a screwdriver between the latch and the foundation. With a smooth twisting motion, release the latch and pull the back cover up. Do the same with all other latches. | ||
# Use a screwdriver to bend the remaining latches and | # Use a screwdriver to bend back the remaining latches and take off the cover. | ||
# Lightly bend the side wall of the case where the connector for connecting external modules is located, and push the controller connector out of the case. He did not become high-ranking, so as not to attract attention. | # Lightly bend the side wall of the case where the connector for connecting external modules is located, and push the controller connector out of the case. He did not become high-ranking, so as not to attract attention. | ||