16 281
правка
Disassembling the controller case/en: различия между версиями
Disassembling the controller case/en (просмотреть исходный код)
Версия 09:02, 19 августа 2022
, 1 год назадНет описания правки
FuzzyBot (обсуждение | вклад) (Обновление для соответствия новой версии исходной страницы.) |
|||
| Строка 1: | Строка 1: | ||
<languages/> | <languages/> | ||
===Tools=== | ===Tools=== | ||
To disassemble | To disassemble the controller, you will need a slotted screwdriver. | ||
===Disassembling=== | ===Disassembling=== | ||
To disassemble the controller, you need to remove the back cover, which is | To disassemble the controller, you need to remove the back cover, which is held on by four latches, and extract the circuit board of controller from the case: | ||
# Place the controller back cover up. | # Place the controller back cover up. | ||
# Insert a screwdriver between the latch and the foundation. With a smooth twisting motion, release the latch and pull the back cover up. Do the same with all other latches. | # Insert a screwdriver between the latch and the foundation. With a smooth twisting motion, release the latch and pull the back cover up. Do the same with all other latches. | ||
# Use a screwdriver to bend back the remaining latches and take off the cover. | # Use a screwdriver to bend back the remaining latches and take off the cover. | ||
# Slightly bend back the side wall of the case where a connector for linking external modules is located, and push the circuit board out of the case. Don’t push too hard, otherwise you will damage the connector. | # Slightly bend back the side wall of the case where a connector for linking external modules is located, and push the circuit board out of the case. Don’t push too hard, otherwise you will damage the connector and elements to PCB. | ||
<gallery mode="packed" heights="150px"> | <gallery mode="packed" heights="150px"> | ||