История
30 мая 2019
Новая страница: «The -d and -x options can be omitted in both cases - they are needed for diagnostic output and hexadecimal data dumps.»
−111
Нет описания правки
+1
Новая страница: «After executing these commands, special files /dev/ttyRS485-1 and /dev/ttyRS485-2 appear in the system (on the PC), corresponding to RS-485 ports of the Wiren Boa…»
−235
Новая страница: «In older versions of controllers, specify ports [/dev/ttyNSC0, /dev/ttyNSC1] or [/dev/ttyAPP1, /dev/ttyAPP4].»
−44
Новая страница: «Run on a computer (Linux based): <pre> socat -d -d -d -x PTY,raw,ispeed=9600,ospeed=9600,parenb=0,cstopb=1,cs8,link=/dev/ttyRS485-1 tcp:192.168.3.12:10010& socat…»
−28
Новая страница: «The second command (service wb-mqtt-serial stop) is to stop the Modbus driver to avoid conflicts when working with RS-485 ports.»
−67
Новая страница: «Note the coding of the number of stop bits: *cstopb=1 — 2 stop bits, *cstopb=0 — 1 stop bit. Option cstopb has the Boolean type; refer to the '''man socat'''…»
−132
Новая страница: «In older versions of controllers, specify ports [/dev/ttyNSC0, /dev/ttyNSC1] or [/dev/ttyAPP1, /dev/ttyAPP4].»
−44
Новая страница: «Run this commands on Wiren Board from root access: <pre> apt-get install socat service wb-mqtt-serial stop </pre> In older versions of controllers, use the ''…»
−37
Новая страница: «Let's say the Wiren Board has 192.168.3.12 IP address.»
−3
Новая страница: «'''Attention!''' These instructions should only be performed on a private subnet. Do not allow RS-485 ports to be accessed over TCP if the Wiren Board is accessib…»
−103
Новая страница: «Access to the RS-485 port of the Wiren Board controller from a computer»
+2834